User manual 3COM SS II ADVANCED RPS 60W MODULE

[. . . ] s Each Power Module in the full redundancy configuration may be considered as supplying half its rated power. The SuperStack II Advanced RPS Power Modules may be hot-inserted into the chassis. It is important that the Power Modules are cooled effectively. We strongly recommend installing the Power Modules as evenly as possible between the top and bottom slots. [. . . ] To connect the power module to the active units, use only the cables supplied with this module or the special `Y' cables available from your supplier. For more general information and warranty details for these products, please refer to SuperStack II Advanced RPS User Guide, part number DUA1607-0AAA0X. The optional SuperStack II Advanced RPS Management Module provides management information to a Network Manager. Details of the management functions are in the Management Module user guide, part number DUA1608-0AAA0X. This guide is written for the installation engineer and the network administrator who manages and maintains the network. ! DISCLAIMER Information in this document is subject to change without notice and does not represent a commitment on the part of 3Com Ireland. 3Com Ireland reserves the right to revise or change this document without obligation of 3Com Ireland to notify any person of the revisions or changes. Information contained in this document is believed to be accurate at the time of publication but no liability whatsoever can be accepted by 3Com Ireland arising out of any use of this information. This document, or any part of it, must not be copied or reproduced on any medium without the prior consent of 3Com Ireland. In the unlikely event that this product is found to be damaged on arrival, or fails to function once installed, you should contact your distributor or reseller for advice. Safety Information L'Information de Sécurité Sicherheitsinformationen ! ACKNOWLEDGEMENTS 3Com, AccessBuilder, NetBuilder, LinkSwitch and LinkBuilder are registered trademarks of 3Com Corporation. Registered trademarks are registered in the United States, and may or may not be registered in other countries. SuperStack is a trademark of 3Com Corporation. Other brand and product names may be registered trademarks or trademarks of their respective holders. Please read the safety information in the Advanced RPS Chassis User Guide before installing the module. Veuillez lire les instructions de sécurité dans le manual d'utilisation du chassis de l'Advanced RPS avant d'installer le module. Lesen sie vor der Installation des Modules die Sicherheitsinformationen in der Advanced RPS Gebrachsanweisung. ! Part Number: DUA1607-2AAA02 Revision: 00 Issued:July 11th, 1997 © 1997 3Com Technologies Power Supply And Fuses All power is supplied and fused from the Advanced RPS chassis. There are no user-replaceable fuses on the Power Modules. Technical Information Mechanical Weight Size 550 g (1. 21 lb) 272 x 87 mm (10. 7 x 3. 4 in) 3C16072 2. 5 amperes 1 ampere 8. 5 amperes 3C16073 2. 5 amperes 1 ampere 15 amperes LEDs LED Function State Indication Input Denotes OK presence Green of AC power. ON OFF AC is connected to relevant input and is OK. AC is not connected to relevant input or there is an AC fault. Power Module is supplying power to a SuperStack II unit. Power Module is not present or Power Module is not required to deliver power or Power Module is disabled by management. Power Module is required to deliver power but cannot. [. . . ] If you are in doubt, consult the product user guide or your supplier for the latest information. Power Module 1/ DC Cable not connected. present, 2/ SuperStack II unit not No Output LED ON connected. 3/ SuperStack II unit does not require RPS power. 4/ SNMP management has disabled the Power Module. [. . . ]