User manual 3M S15I INSTRUCTIONS MANUAL

[. . . ] Contact a 3M authorized service provider for service. - Do not allow water or other liquids to enter the projector. To reduce the risk associated with environmental contamination due to mercury: - Dispose of lamp cartridge in accordance with applicable federal, state and local regulations. - Contact a 3M authorized service provider if the projector becomes damaged. [. . . ] A too long cable may cause certain picture degradation. Please consult with your dealer for details. For cables that have a core only at one end, connect the core to the projector. Make sure that you connect devices to the correct port. Incorrect connection may result in malfunction and/or damage to the device and/or projector. Do not place the projector in the side/front/rear-up position, except care of the air 8. 15. 8 3MTM Multimedia Projector S15i Product Safety Guide © 3M 2006 © 3M 2006 3MTM Multimedia Projector S15i Product Safety Guide 9 ENGLISH Product Safety Labels ENGLISH Lamp Lamp Operation: The following symptoms may indicate a lamp in need of replacement: · LAMP indicator lights up red. WARNING · To reduce the risk associated with environmental contamination due to mercury in the projection lamp: - Dispose of lamp cartridge in accordance with applicable federal, state and local regulations. - The lamp in this product contains mercuy. Dispose of projection lamp in a manner that is consistent with your local hazardous waste regulations for mercury. - For recycling and disposal information, contact your respective governmental agencies. In U. S. , contact the Electronic Industries Alliance at www. lamprecycle. org In Canada, contact the Electronic Product Stewardship Canada at www. epsc. ca Display Lamp Operation Hours To determine the lamp operation hours, follow these steps: 1. While the projector is running, press the MENU button on the remote control. Choose the "OPTION" using the button, and press the button or the ENTER button. Choose the "LAMP TIME" using the button. The operating time of the lamp will be displayed. The lamp time is the time counted after the last resetting. Note Please reset the lamp time only when you have replaced the lamp, for a suitable indication about the lamp. Reset Lamp Hours (1) Press the MENU button to display a menu. Only when the EASY MENU has appeared, please perform the next step (2). appear. time. 10 3MTM Multimedia Projector S15i Product Safety Guide © 3M 2006 The glass lamp used in this projector contains small amounts of mercury and operates at high pressure and at high temperature and may unexpectedly shatter. Each lamp has a different lifetime and can fail in different ways, including a rupture with a loud bang or simply burn out. In the event of a lamp rupture, be sure to follow the instructions. WARNING · To reduce the risk associated with exposure to hazardous voltage: - Disconnect power cord when the projector is not in use, during lamp replacement, and while cleaning. - Do not attempt to service the projector - there are no user serviceable parts, other than the lamp cartridge, inside the projector. Contact a 3M authorized service provider for service. [. . . ] All other products are trademarks or registered trademarks of their respective companies. © 3M 2006 3MTM Multimedia Projector S15i Product Safety Guide 13 ENGLISH Warranty Important Notice All statements, technical information, and recommendations related to 3M's products are based on information believed to be eliable, but the accuracy or completeness is not guaranteed. Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability associated with such use. Any statements related to the product which are not contained in 3M's current publications, or any contrary statements contained on your purchase order shall have no force or effect unless expressly agreed upon, in Let us help you make the most of your next presentation. [. . . ]