User manual A-LINK ROADRUNNER 24AP QUICK INSTALLATION GUIDE

[. . . ] Connect phone cable from ADSL -line to modem ADSL -port. Reset ­ button, where modem can be reset back to factory defaults. Connect power supply to modem power port. You can use other external WLAN ­antennas also. [. . . ] Add your ISP setting in third step"3. Country = Others Internet Service Provider = ISP use PPPoE or ISP use PPPoA IPTV = No VPI/VCI = < Add your ISP VPI/VCI values > Encapsulation = LLC or VC MUX Username = <Type username for PPP connection> Password = <Type password for PPP connection> Confirm Password = <Type password again> Press Next button. Confirm" you can check and confirm modified values before saving. (Use this when modem is in factory defaults) (Password = password ) | | | /\ | | | | Yes Check from STATUS menu, that connection with correct VPI/VCI values has IP address *. ||||| | | | | No If your connection needs other VPI/VCI values than modem has already configured, |||| make settings with your ISP VPI/VCI values as in step 3 are advised. |||| If you have PPP connection, make settings as in step 5 is advised *. |||||| | | | | | Yes Check your ADSL line settings from your ISP. ||||| | | | | No You can try to reset the modem to factory defaults by pressing reset on back of the product |||| for example with needle when power is on. if reset does not help , send it to A-Link warranty **. |||| | | | No Check your computer network settings as in step 1 have been told. |||| | | | No You can try to reset the modem to factory defaults by pressing reset on back of the product ||| for example with needle when power is on. Make sure that network cable other end is connected to computer || network card and other end is connected to modem port 1, 2 or 3. Check that computer network card and cable are OK. Is phone cable connected from modem to ADSL -line?Check from your ISP that ADSL line do not have problems. Is power supply connected to modem power port and power switched on?(Use this when modem is in factory defaults) /\ | Yes Is your computer connected to wireless network called "default"?(Password = password ) | | /\ | | | Yes Check from STATUS menu, that connection with correct VPI/VCI values has IP address *. |||| | | | No If your connection needs other VPI/VCI values than modem has already configured, ||| make settings with your ISP VPI/VCI values as in step 3 are advised. ||| If you have PPP connection, make settings as in step 5 is advised *. ||||| | | | | Yes Check your ADSL line settings from your ISP. |||| | | | No You can try to reset the modem to factory defaults by pressing reset on back of the product ||| for example with needle when power is on. [. . . ] change ESSID Broadcast to DISABLE Note!Network name can not contain any special characters or spaces. Authentication = Pre-shared Key Pre-shared key type = Passphrase (8~63 characters) Pre-shared Key = < Type password here > Press Save Settings bottom-edge of page. Write your password to page 12 for future use with your computer. [. . . ]