User manual A-ONE DV5601HDMI

[. . . ] Use the number keys to enter your 4-digit Device Code, the indicator should go out immediately. TV) responds to your invoked function correctly, you have entered the right Device Code. Otherwise, repeat the above setup instructions with the rest available Device Codes until your device (e. TV) responds to your invoked function, and most keys work correctly. [. . . ] TV), press the " " key repeatedly, slowly and patiently until the device has been turned off. Once your device has been turned off, immediately press Device Mode Key (e. TV ) to lock in code and the indicator should go out. * Simply repeat the above setup procedures to search the Device Code for your VCR, SAT, DVD or CTV. (Remember to press a correct Device Mode Key and correct Magic Search Code in step 2-5 above) IMPORTANT: ­ If the power on/off function of your device is not infra-red controlled - you need to follow steps 2 to 6 above and start searching :· Press " " and another important function key alternately until your device responds to the expected function, press the same Device Mode Key (e. Note: ­ DVD, CTV and other device codes can be searched and locked into any device modes except "TV" & "VCR" modes. Just simply press the corresponding device mode key in step 2 & 5 and enter an appropriate Magic Search Code for your DVD, CTV and other devices. ­ Each time you press the " ", the URC will skip to the next code and send out a POWER signal trying to turn off your device. If you failed to stop pressing " " in time when your device has been turned off, turn on your device again immediately. Before the indicator goes out, press " " on the URC to skip backward. Repeat the step 7 above and lock in code. ­ If the indicator flashes twice after your pressing of " " key, you are already at the last code of the library. Press " CH+ " and " VOL­ " to resume the URC and repeat carefully the above procedures to search again. Once you have set up the URC for your A/V equipment, it works like your original remote controls. To operate, just aim it at your equipment, press an appropriate device mode key and invoke the desired function by pressing a corresponding key on the URC. The indicator flashes during signal transmission and as confirmation of key touch. Punch through channel allows you to operate channel up and down without having to switch the device modes repeatedly even when your URC is in other operating modes. Release " CH+ " (the indicator flashes once if the setting is activated). Release " CH ­ " (the indicator flashes twice if the setting is deactivated). Punch through volume allows you to operate volume up and down without having to switch the device modes repeatedly even when your URC is in other operating modes. [. . . ] Do not disassemble your URC, it contains no user-serviceable parts. Check your A/V device, if the device's main switch is turned off, your URC could not operate your device. Check whether your batteries are inserted properly and are in correct +/- marks. Check whether you have pressed the corresponding device mode key for your device. [. . . ]