User manual ABC-DESIGN TURBO 6S

[. . . ] NB: Please do not use any product for lubrication other than silicone oil or silicone spray lubricant. â· Regular care and upkeep have a major part to play in maintaining the safety and value of the product. Exposure to such things as salt in the air, road-gritting salt or acid rain will encourage the onset of corrosion, as will inappropriate storage of the product. In serious cases of soiling please clean the surface coating immediately. [. . . ] â· Do not make any modifications to the product which compromise its safety. â· Keep this product away from fire and other sources of heat. No claims may be made for natural wear and tear or for damage caused by undue demands on the product or by exceeding the permissible load. â· No claims may be made for damage caused by improper use. â· No claims may be made for damage caused by incorrect assembly or operation. â· No claims may be made for damage caused by improper modifications to the product. â· Areas of rust may appear through lack of maintenance or improper care and do not constitute a fault with the product. â· Scratch marks are normal signs of wear and do not constitute a fault with the product. â· Mildew is likely to appear on textiles which are not dried out after getting wet and cannot be attributed to shortcomings in production conditions. â· The product may fade if exposed to sunlight, perspiration and detergents, or if subject to abrasion or excessive washing, therefore fading cannot be attributed to a fault with the product. â· No claims may be made for wheels which become worn out as a natural result of wear and tear. Attaching and converting the seat Attach the seat by placing it on the frame until it clicks into place. To convert the seat, press the buttons on both adapters and lift up the seat. Attaching and removing the hood Lower the hood down onto the attachment To remove the hood, press the buttons in on both sides of the hood. Adjusting the backrest To adjust the backrest, pull the retainer on the rear of the backrest upwards and then adjust the height. When you have reached the required position, let go of the retainer to allow the backrest to remain in that position. Fitting and removing the guard rail Fit the guard rail by inserting it in the plastic mounts on both sides. To remove the guard rail from the pushchair, press in the buttons on both sides and pull the guard rail off away from the pushchair. To adjust the height of the guard rail, press and hold down the buttons on each side and push the bar up or down. When the handle is at the required height, let go of the button again so that the handle will remain locked in this position. Adjusting the leg rest To adjust the leg rest, press in the buttons on both sides and then adjust the height. Let go of the buttons again so that the leg rest clicks into place. [. . . ] fasten and tighten the belt on the rear of the backrest. Flip up the footrest at the lower end of the cot and secure the strap around the footrest. Fitting the apron Take the lower part of the foot muff out of the bag. Zip the top and bottom parts of the foot muff together. [. . . ]