User manual ACER AL718

[. . . ] 4 OSD options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 OSD Menu . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Brightness & Contrast . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If this does not resolve the problem do not attempt to repair the monitor by yourself; opening or removing covers can lead to injury or death through electrocution among other hazards. Please contact a qualified engineer if you find the troubleshooting section does not help. · 1 English Table of Contents English Package contents LCD Monitor Power Cord Audio Cable User Manual Installation instructions Assembling the Monitor 1. Position the monitor on top of the stand. 2. Connect the stand into the neck of the monitor along the track. Detaching the Monitor Important First, find a clean, flat surface to place the monitor after removing it from the stand. Place a clean dry cloth under the monitor to protect it further. Pull the monitor slightly up and away from the stand. 2 Adjusting the Viewing Angle The viewing angle of the monitor ranges from 0°~20°. Caution: Make sure that the computer and the monitor are both disconnected from the power supply. English Connecting the Devices Power Code Audio cable VGA Cable (Attached) Attach the monitor to the power cord which should then be inserted into a properly grounded electric socket. Connect the audio input socket of the LCD monitor and the computer by means of the audio cable. Connect the signal cable to the VGA output socket of the graphics card on the computer. Then tighten the thumbscrews on the connector. WARNING: The D-Sub 15 pin plug of the VGA cable is trapezoid in shape. Make sure the shape of the plug matches the shape of the socket it is inserted into, and that none of the pins are bent or otherwise damaged. Switching the Power First, switch the power on to the monitor, then switch the power on to the computer. When you see the LED on the power button go green, this indicates the computer is ready for use. Allow about 10 seconds for the video signal to appear. If you do not see the green light on the power button or a video signal, check the connections. 3 English Adjusting display settings External Controls 1. AUTO If OSD is active, press to enter a selection in OSD. If OSD is inactive, press and the monitor will automatically optimize the position, clock and phase of your display. Power on/off Green: power on Orange: in sleep mode If OSD is active, press to select or adjust OSD options. [. . . ] Ensure the video cable is securely connected to the back of the monitor and the computer. Move the mouse or press any key on the keyboard to bring the monitor out of "active off" mode. See "Color Adjustment" to adjust RGB color or to select color temperature. [. . . ]