User manual ACER ASPIRE 5820TG

[. . . ] Should the programs prove defective following their purchase, the buyer (and not Acer Incorporated, its distributor, or its dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software. Acer is a registered trademark of Acer Corporation. Intel is a registered trademark of Intel Corporation. Pentium and Pentium II/III are trademarks of Intel Corporation. Other brand and product names are trademarks and/or registered trademarks of their respective holders. III Conventions The following conventions are used in this manual: SCREEN MESSAGES NOTE Denotes actual messages that appear on screen. [. . . ] Lift the Thermal Module clear of the Mainboard. 68 Chapter 3 Removing the Speaker Module 1. See "Removing the Mainboard" on page 63. Remove the two securing screws (one for each Speaker). Step Speaker Module M2*4 Size 2 Quantity Screw Type 3. Lift the left Speaker out of the Lower Cover, rear edge first as shown. Chapter 3 69 4. Remove the Speaker cable from the cable channel. Ensure that the cable is free from all cable clips. 5. Lift the right Speaker out of the Lower Cover, rear edge first as shown. 6. Lift the Speaker Module clear of the Lower Cover. 70 Chapter 3 Removing the LCD Module IMPORTANT: Cable paths and positioning may not represent the actual model. During the removal and replacement of the LCD Module, ensure all available cable channels and clips are used and that the cables are replaced in the same position. NOTE: The following procedure outlines the steps to remove the LCD Module on models with 3G functionality. Models that do not support 3G do not require the removal of the yellow and blue Antenna cables detailed below. Continue moving along the top, prying the bezel away from the LCD Module. If necessary, use a plastic pry to release the corners of the bezel. 76 Chapter 3 4. Work down the left side as shown, then pry apart the bottom edge to remove the bezel. 5. Lift up the bezel and remove it from the LCD Module. Chapter 3 77 Removing the Camera Board 1. See "Removing the LCD Bezel" on page 76. Disconnect the cable from the Camera Board as shown. 3. Remove the Camera Board from the LCD Module. 78 Chapter 3 Removing the LCD Panel 1. See "Removing the Camera Board" on page 78. Remove the two securing screws from the LCD Panel. Step LCD Panel M2*4 Size 2 Quantity Screw Type 3. Remove the LVDS cable from the cable channel in the bracket. 4. Lift the panel as shown to expose the LVDS and Microphone cables. IMPORTANT: Do not remove the panel at this stage to avoid damaging the cables. Chapter 3 79 5. [. . . ] Copy the KAV60. fd BIOS file into USB flash disk root directory. NOTE: Do not place any other *. fd file in the USB flash disk root directory. To use the Crisis USB key, do the following: 1. Press Fn + ESC button then plug in AC power. [. . . ]