User manual ACER ASPIRE 5830TG

[. . . ] Should the programs prove defective following their purchase, the buyer (and not Acer Incorporated, its distributor, or its dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software. Acer is a registered trademark of Acer Corporation. Intel is a registered trademark of Intel Corporation. Pentium Dual-Core, Celeron Dual-Core, Core 2 Duo, Core 2 Quad, Celeron, and combinations thereof, are trademarks of Intel Corporation. Other brand and product names are trademarks and/or registered trademarks of their respective holders. iv Conventions The following conventions are used in this manual: SCREEN MESSAGES NOTE WARNING CAUTION IMPORTANT Denotes actual messages that appear on screen. [. . . ] System halts after displaying this message. This message is displayed by the AMIBIOS8 when the RAM read/write test fails. The base memory (memory below 1MB) size that is reported in the CMOS (offset 15h) mismatches with the actual size detected. This condition may occur when the hole is set at 512K base memory or when CMOS is corrupted. Parity Error RAM R/W test failed CMOS Memory Size Wrong Boot Message Displayed Boot Failure . . . Invalid Boot Diskette Drive Not Ready A: Drive Error Description This is a generic message indicating the BIOS could not boot from a particular device. This message is usually followed by other information concerning the device. A diskette was found in the drive, but it is not configured as a bootable diskette. The BIOS was unable to access the drive because it indicated it was not ready for data transfer. This is often reported by drives when no media is present. The BIOS attempted to configure the A: drive during POST, but was unable to properly configure the device. This may be due to a bad cable or faulty diskette drive. Chapter 4 48 Message Displayed B: Drive Error Insert BOOT diskette in A: Reboot and Select proper Boot device or Insert Boot Media in selected Boot device NO ROM BASIC Description The BIOS attempted to configure the B: drive during POST, but was unable to properly configure the device. This message is typically displayed when the BIOS is trying to detect and configure IDE/ATAPI devices in POST. The IDE/ATAPI device configured as Slave in the 6th IDE controller could not be properly initialized by the BIOS. This message is typically displayed when the BIOS is trying to detect and configure IDE/ATAPI devices in POST. The IDE/ATAPI device configured as Primary Master failed an ATAPI compatibility test. This message is typically displayed when the BIOS is trying to detect and configure IDE/ ATAPI devices in POST. The IDE/ATAPI device configured as Primary Slave failed an ATAPI compatibility test. This message is typically displayed when the BIOS is trying to detect and configure IDE/ATAPI devices in POST. The IDE/ATAPI device configured as Secondary Master failed an ATAPI compatibility test. This message is typically displayed when the BIOS is trying to detect and configure IDE/ ATAPI devices in POST. The IDE/ATAPI device configured as Secondary Slave failed an ATAPI compatibility test. This message is typically displayed when the BIOS is trying to detect and configure IDE/ ATAPI devices in POST. [. . . ] Step 10:It may takes half and hours to create RAID 0. After create completely, it will ask to reboot to finish create RAID 0. 93 Chapter 7 2-6:Create a"RAID Ready" System into" RAID 1" with two Hard Drives by `Create RAID Volume '. Step 1:Install WIN7 OS with one SATA HDD. Step 2:Shut down the system, then add another two serial ATA hard drives in the system. Step 3:Boot to OS desktop, open the Intel® Matrix Storage Console. Step 4:Click on the by`Create RAID Volume' to create a RAID volume. [. . . ]