User manual ACER ASPIRE A3-600

[. . . ] After descaling is done, the steam function will be restored. This takes place regardless of the type of water used. Sound and light Calc-Clean reminder -- After 1 to 3 months of use, the Calc-Clean light starts flashing and the appliance starts beeping to indicate that you have to perform the Calc-Clean process (Fig. -- You can continue steam ironing for 1 hour while the Calc-Clean light flashes and the appliance beeps. [. . . ] €5) Tip:You can continue to dry iron by not pressing the steam trigger. Performing the Calc-Clean process with the Smart Calc-Clean container Do not leave the appliance unattended during the Calc-Clean process. 7 Caution: Do not interrupt the process by lifting the iron up from the Calc-Clean container, as hot water and steam will come out of the soleplate. 2 Make sure that the appliance is plugged in and switched ON during the Calc-Clean process (Fig. 4 Place the Smart Calc-Clean container on the ironing board or any other even, stable surface (Fig. 5 Place the iron stably on the Smart Calc-Clean container. note:The Smart Calc-Clean container has been designed to collect scale particles and hot water during the Calc-Clean process. It is perfectly safe to rest the iron on this container during the entire process. 6 Press and hold the Calc-Clean button for 2 seconds until you hear short beeps (Fig. 7 During the Calc-Clean process, you hear short beeps and a pumping sound. Wait approximately 2 minutes for the appliance to complete the process (Fig. Perform the Calc-Clean process to enable the steam function again (see chapter ‘IMPORTANT - Cleaning and maintenance’). The Calc-Clean light flashes and the appliance beeps. You have not done or have not The Calc-Clean light flashes and/or completed the Calc-Clean process. You have not done or have not The Calc-Clean completed the Calc-Clean light flashes and process. The appliance beeps every time I press the steam trigger. This happens automatically when the steam generator has not been used or the steam trigger has not been pressed for more than 15 minutes. Set the on/off switch to ‘off ’ position and then to ‘on’ position. The appliance produces a loud pumping sound. Fill the water tank with water and press the steam trigger until the pumping sound becomes softer and steam comes out of the soleplate. ENGLISH Problem Water droplets come out of the soleplate. Possible cause After the Calc-Clean process, remaining water may drip out of the soleplate. [. . . ] Solution 9 Wipe the soleplate dry with a piece of cloth. If the Calc-Clean light still flashes and the appliance still beeps, perform the Calc-Clean process (see chapter ‘IMPORTANT - Cleaning and maintenance’). You have to perform the Calc-Clean process again (see chapter ‘IMPORTANT Cleaning and maintenance’). The Calc-Clean process has not been completed. [. . . ]