User manual ACER ASPIRE E1-530G ǔ

[. . . ] -- If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard. -- If the appliance is subjected to a major change in temperature, pressure or humidity, let the appliance acclimatise for 30 minutes before you use it. -- Do not use the appliance if any of its parts is damaged or broken, as this may cause injury. -- Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. [. . . ] 5 Slowly move the trimmer against the hair growth direction. Press lightly and always make sure the surface of the comb  is in full contact with the skin. Note:When you trim for the first time, start at the highest setting (18mm) to familiarise yourself with the appliance. Trimming nose and ear hair Trimming nose hair 1 1 Place the nose/ear trimmer on the handle (1). Turn the nose/ear trimmer clockwise to fix it (2). 3 Switch on the appliance and insert the tip of the trimmer into one of your nostrils. 4 Slowly move the tip in and out while turning it round at the same time to remove unwanted hair. To reduce the tickling effect, make sure that you press the side of the tip firmly against the skin. Trimming ear hair 1 Attach the nose/ear trimmer onto the handle. English 3 Switch on the appliance and move the tip softly round the ear to remove hairs that stick out beyond the rim of the ear. 9 4 Carefully insert the tip into the outer ear channel. Make sure the battery is completely empty when you remove it. Be careful, the battery strips and housing parts are very sharp. 1 Make sure the appliance is disconnected from the mains. 3 Remove the on/off slide with a flathead screwdriver. 4 Remove the front panel of the appliance with a flathead screwdriver. 5 To release the inner part of the handle, insert a flathead screwdriver in the hole (1). Tilt the screwdriver upwards to push the inner part out of the handle (2). 6 Pull the inner part out of the handle. English 11 8 Unhook and remove the battery cover to expose the rechargeable battery. 9 Cut the wires to separate the rechargeable battery from the inner part. Guarantee and support If you need information or support, please visit www. [. . . ] If the charging light does not light up, check whether there is a power failure or if the wall socket is live. If there is no power failure and the wall socket is live but the charging light still does not light up, take the appliance to your dealer or a Philips service centre. Switch off the appliance and charge it for 10 hours (see chapter ‘Charging’). The appliance does not work when it is connected to the mains. [. . . ]