User manual ACER ASPIRE ZC-606

[. . . ] L, Via Lepetit, 40, 20020 Lainate (MI) Italy Aspire ZC-606 2014 188 kWh/year 211 kWh/year adjustments when discrete graphics cards Not applicable are enabled (from 1 July 2014) ETEC allowance with capability adjustments when discrete graphics cards are disabled (from 1 January 2016) ETEC allowance with capability 134 kWh/year Not applicable 150 kWh/year adjustments when discrete graphics cards Not applicable are enabled (from 1 January 2016) Whether all discrete graphics card are Not applicable enabled during the test Whether switchable graphics mode with Not applicable UMA is driving the display during the test ETEC of highest power-demanding 34. [. . . ] 347 B Minimum number of loading cycles that the batteries can withstand Configuration of memory Configuration of internal storage Configuration of discrete television tuner Configuration of discrete audio card Configuration of discrete graphics cards Configuration of discrete graphics cards category The battery in this product cannot be easily replaced by users themselves For products with an integrated display, the total content of mercury is Not applicable 2~8 GB 1 piece Not applicable Not applicable Not applicable Not applicable Not applicable 0 mg Not applicable 2~8 GB 2 pieces Not applicable Not applicable Not applicable Not applicable Not applicable 0 mg Measurement methodology for ETEC COMMISSION REGULATION (EU) No 617/2013 of 26 June 2013 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for computers and computer servers: ANNEX II Ecodesign requirements and timetable: 1. Measurement methodology for sleep mode Measurement methodology for off mode EN 62623:2013 — Desktop and notebook computers — Measurement of energy consumption: 5. Power supplies — Determination of no-load power and average efficiency of active modes. Method for determination of sound power levels of equipment in reverberation test rooms; 7. Method for determination of sound power levels of equipment under essentially free-field conditions over a reflecting plane; Annex C. 15 Equipment category: personal computers and workstations. [. . . ] Sequence of events required to reach the mode where the equipment automatically Not applicable changes to off mode The length of time after a period of user inactivity in which the computer automatically reaches a power mode that 30 minutes has a lower power demand requirement than sleep mode The length of time before the display sleep mode is set to activate after user inactivity User information on the energy-saving potential of power management functionality 10 minutes http://www. [. . . ]