User manual ACER B286HL QUICK START GUIDE

[. . . ] If you do not agree to this license, do not download, install, copy or use the software. Third party copyrights are property of their respective owners. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: Redistribution’s of source code must retain the above copyright notice, this list of conditions and the following disclaimer. Redistribution’s in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution. [. . . ] Power lamp Charging lamp Turn on the Power Switch at the bottom of the product. After aligning the charge pins of the main unit with the charge pin of the charger station, press the main unit until you hear a Recharging power sound from the charger. Check the charge status of the vacuum cleaning robot. - When charging starts, “the amount of remaining battery power” and “ ” are displayed on the status display panel in this sequence. - When charging is complete, the battery level indicator and “FULL” will be displayed in the display panel. –  When the battery level display flashes while cleaning, the vacuum cleaning robot stops vacuuming and automatically charges itself at the charger. –  If the vacuum cleaning robot starts the current cleaning run at a location other than the charging station and fails to locate the charging station while cleaning, it will stop near the location where it started cleaning. –  When the battery level flashes and “Lo” is displayed while cleaning, vacuum cleaning robot cannot be operated by the remote control or the buttons on the main unit. In this case, directly carry the vacuum cleaning robot to the charger to charge the battery. (This is when the battery is completely discharged. 15 8:43:30 AM NOTE • When the product is initially purchased, it will take about 180 minutes to fully charge the battery and will run for about 100 minutes. Contact your nearest customer care center. ˆ An increased charging time and a shorter battery life indicates the near end of the battery life. Please contact an authorized customer care center to replace your battery. The rechargeable battery incorporated in this product is not user replaceable. For information on its replacement, please contact your service provider. 15 8:43:30 AM Setting the Time The clock displays the current time. You can change the current time with the following steps. –  You can only set the time using the remote control. Press the or button to set the day of the week. - The value you set will blink and the settings are completed. Blinks Canceling the Settings Remote Control - Press the Start/Stop button to cancel the settings and exit Time Set mode. [. . . ] SOLUTION • Turn off the Power Switch at the bottom and move the vacuum cleaning robot to a different location. €¢ Turn off the Power Switch at the bottom and remove the foreign substance from the power brush. €¢ Turn off the Power Switch at the bottom and remove the foreign substance from the left driving wheel. €¢ Turn off the Power Switch at the bottom and remove the foreign substance from the right driving wheel. [. . . ]