User manual ACER P1373WB

[. . . ] Com/app/answers/detail/a_id/984 Trademarks ACER, the ACER logo, ReadyNAS, ProSafe, ProSecure, Smart Control Center, Auto Uplink, X-RAID2, and NeoTV are trademarks or registered trademarks of ACER, Inc. microsoft , Windows , Windows NT , and Vista are registered trademarks of Microsoft Corporation. Other brand and product names are registered trademarks or trademarks of their respective holders. Statement of Conditions To improve internal design, operational function, and/or reliability, ACER reserves the right to make changes to the products described in this document without notice. [. . . ] Click Refresh to refresh the page with the most current data from the switch. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. If you change any of the settings on the page, click Apply to send the updated configuration to the switch. configuration changes take effect immediately. ARP Entry Management Use this page to remove certain entries from the ARP Table. Click Routing  ARP, then click the Advanced  ARP Entry Management link. 168 | Chapter 5: Configuring Routing P1373WB Smart Switch Software Administration Manual Table 5-11. ARP Entry Management Fields Field Remove from Table Description Allows you to remove certain entries from the ARP Table. The choices listed specify the type of ARP Entry to be deleted: • All Dynamic Entries • All Dynamic and Gateway Entries • Specific Dynamic / Gateway Entry. Selecting this allows you to specify the required IP address. Select if you do not want to delete any entry from the ARP Table. This mapping table indicates the CoS queue to which the packet should be forwarded on the appropriate egress port(s). Of course, the trusted field must exist in the packet for the mapping table to be of any use, so there are default actions performed when this is not the case. These actions involve directing the packet to a specific CoS level configured for the ingress port as a whole, based on the existing port default priority as mapped to a traffic class by the current 802. Alternatively, when a port is configured as untrusted, it does not trust any incoming packet priority designation and uses the port default priority value instead. All packets arriving at the ingress of an untrusted port are directed to a specific CoS queue on the appropriate egress port(s), in accordance with the configured default priority of the ingress port. This process is also used for cases where a trusted port mapping is unable to be honored, such as when a non-IP packet arrives at a port configured to trust the IP DSCP value. Select the Global radio button to specify the CoS configurable interfaces. The option “Global” represents the most recent global configuration settings. Alternatively, you can select the Interface radio button to apply trust mode settings to individual interfaces. The per-interface setting overrides the global settings. 172 | Chapter 6: Configuring Quality of Service P1373WB Smart Switch Software Administration Manual 2. [. . . ] Failure of the end-user to comply with the applicable requirements may result in unlawful operation and adverse action against the end-user by the applicable National regulatory authority. Note: This product’s firmware limits operation to only the channels allowed in a particular Region or Country. Therefore, all options described in this user's guide may not be available in your version of the product. Appendix C: Notification of Compliance | 311 P1373WB Smart Switch Software Administration Manual Europe – EU Declaration of Conformity Marking by the above symbol indicates compliance with the Essential Requirements of the R&TTE Directive of the European Union (1999/5/EC). [. . . ]