User manual ACER S1213HN

[. . . ] Use the attached RGB cable, RS-232C cable with this equipment so as to keep interference within the limit of a FCC Class A device. The projector automatically shuts off when the lamp is used up in about 2, 000 hours and cannot be used until lamp replacement. DO NOT LOOK DIRECTLY INTO THE LENS WHEN PROJECTOR IS IN THE POWER ON MODE. When using the projector in Europe COMPLIANCE NOTICE This LCD - Video Projector complies with the requirements of the EC Directive 89/336/EEC "EMC Directive" as amended by Directive 93/68/EEC and 73/23/EEC "Low Voltage Directive" as amended by Directive 93/68/EEC. [. . . ] · The settings with 2 mark, you should press the ENTER button after selecting. INSTALLATION 3. Press the ENTER button (or } button). Opt XGA60 OFF 0° OFF OFF INSTALLATION IMAGE REVERSE KEYSTONE AUTO POWER ON AUTO POWER OFF EN ­ 15 ENGLISH CONTRAST BRIGHTNESS COLOR MATRIX ± 30 ± 30 1 2 3 USER OFF STANDARD HIGH LOW USER ± 10 ± 10 ± 10 RED GREEN BLUE YELLOW CYAN MAGENTA ± 10 ± 10 ± 10 ± 10 ± 10 ± 10 Menu operation (continued) 1 IMAGE CONTRAST . . . . . . . . The contrast becomes higher XGA60 as the number increases. The image becomes brighter as CONTRAST 0 the number increases. Adjusts color balance in each color of the image. The sharpness becomes TINT 0 sharper as the number increases. The color balance of the image shifts green as the number increases and shifts to purple as the number decreases (displays only when the source is selected to VIDEO). · When the TV50 (PAL, SECAM) signal is inputted, you cannot adjust the TINT. Adjusts the color intensity of the image (displays only when the source is selected to VIDEO). Opt 2 INSTALLATION IMAGE REVERSE Use to reverse or invert the projected image. MIRROR is XGA60 used for rear projection. MIRROR INVERT is effective INSTALLATION when the projector is ceiling-mounted. ( / English / Español / Deutsch / Français / Italiano / ) Opt A A A A EN ­ 16 4 SIGNAL MEMORY CALL . . . . . . . . Use to adjust the horizontal position of the image. Use to adjust the vertical position of the image. Use to synchronize the projector with PC input signals so that the image is not blurred. Use to avoid image noise such as wide stripes. The unit adjusts itself automatically when connected to either DVD players with a component video output terminal (Y, CB, CR or Y, PB, PR) or equipment with HDTV signal output capabilities. In cases where the unit is connected to equipment that include an RGB output terminal and which output HDTV signals, adjust the unit to RGB mode. Adjusts the image when curving near the top. Opt XGA60 AUTO 208 22 24 1056 RGB AUTO SIGNAL A U MEMORY CALL HORIZ. TRACKING RGB RGB COMPUTER INPUT HOLD USER MEMORIZE DELETE DEFAULT 5 SIGNAL - USER (Normally, there is no need for adjustments. ) SIGNAL­USER CLAMP POSITION/ CLAMP POSITION 0 CLAMP WIDTH . . . . . . . . . If you use something similar, the brighter colors of the CLAMP WIDTH +5 projected image may become blurred. PIXELS 800 CLAMP POSITION or CLAMP WIDTH. The image size PLL AUTO grows wider as the number increases. [. . . ] · The PC monitor is not turned on. · This is typical of the LCD projector. · The operation is incorrectly made due to noise or interference. · Plug the connecting cable securely into the terminal. · Install the projector far away from other equipment. [. . . ]