User manual ACER V66LT

[. . . ] See Figure 13. Figure 1-3 Connecting the Keyboard 1-4 AcerPower 2100 User's Guide 1. 3. 2 Connecting the Monitor Plug the monitor signal cable into the VGA connector on the rear panel. Figure 1-4 Connecting the Monitor Chapter 1 - Getting Started 1-5 1. 3. 3 Connecting the Mouse Plug the mouse cable into the mouse connector on the rear panel. Figure 1-5 Connecting the Mouse 1-6 AcerPower 2100 User's Guide 1. 3. 4 Connecting the Printer (Optional) If you have a parallel printer, connect it to the parallel port on the rear panel. See Figure 1-6. Figure 1-6 Connecting the Parallel Printer If you have a serial printer or other serial peripheral, connect it to the serial port (COM1). Chapter 1 - Getting Started 1-7 1. 3. 5 Complete System Connections After connecting all the components, plug one end of the power supply cable into the system power socket. Plug the other end of the power supply cable into a wall outlet. [. . . ] The CRT monitor retains very high voltage levels, even after the power is turned off. Refer all monitor service to qualified service technicians. 1-14 AcerPower 2100 User's Guide Keyboard is Dead · Is the keyboard cable plugged in?Turn off the system unit and plug in the keyboard. Do not plug or unplug the keyboard while the power is on. Printer Doesn't Work · · · · · Is the printer power turned on?Is the printer cable connected to the correct port (serial or parallel)?Are your application and the printer configured for the same operating values?Be sure there is no conflict with any port and add-on card. Check the printer's status indicator lights. To prevent signal interference, neatly fold or coil excess cable length. Add-on Card Fails Intermittently · Do two add-on cards have conflicting addresses? If You Receive an Error Message · Read the corrective actions in Table 1-1 in section 1. 7. Chapter 1 - Getting Started 1-15 1. 7 Error Messages In the event that you receive an error message, do not continue using the computer. Note the message and take corrective action immediately. This section describes the different types of error messages and suggests corrective measures. There are two general types of error messages: · · Software System 1. 7. 1 Software Error Messages Software error messages are returned by your operating system or application. These messages typically appear after you boot the operating system or when you run your applications. If you receive this type of message, consult your application or operating system manual for help. 1. 7. 2 System Error Messages A system error message indicates a problem with the computer itself. These messages normally appear during the power-on self-test, before the operating system prompt appears. [. . . ] An incorrect Setup configuration is a major cause of power-on error messages, especially for a new system. Remove the system cover according to the directions in the system housing installation guide. Check that the system board and any expansion boards are set correctly. [. . . ]