User manual ACESONIC AM-170

[. . . ] KEY CONTROL - The line of buttons allows you to raise or lower the key by six (6) semi-tones. The center button is the original (natural) key, and flat is to the left while sharp is to the right. MASTER MICROPHONE VOLUME ­ This dial controls the master volume for all three microphone inputs. Turning clockwise raises the volume. If you are is missing any of these items, contact your Acesonic dealer at once. · User's Manual, Warranty Card 3. [. . . ] VIDEO OUT ­ This RCA output jack works with the Audio outs below it (see Item #6, below) to supply a composite signal to an external device. 3 6. AUDIO OUT ­ RCA jacks for Audio out. 7. REC OUT AND LINE OUT ­ These RCA jacks are for sending Audio to external recording units or other devices. SUB AND MIC OUTPUTS ­ The SUB RCA jacks send Audio signals of appropriate frequency to subwoofers. The MIC jacks send High and Low signals to other audio devices. SPEAKER CONNECTIONS ­ The Left and Right pairs of posts connect to your speakers. 10. SOURCE INPUTS ­ The jacks in this location accept inputs from BGM, AUX, DVD and CDG. S-VIDEO OUT ­ This output jack sends an S-Video signal for input to TVs and TV-connected devices that use the format. VOLTAGE SELECT ­ This switch selects between 115 and 230 volts for AC power. AC INPUT ­ This is where the power cord connects to the back of the AM-170. Remote Control Operations 1. KEY CONTROL ­ The b and # keys adjust the pitch up and down by semitones, while the center selection (natural symbol) returns the program material to its original key. 2. MIC VOLUME ­ The + and - buttons control the Volume of the microphone(s) being used. MUSIC VOLUME ­ Increase or decrease the music master output Volume with the + and buttons. SOURCE SELECTIONS : 1 2 3 4 5 6 7 · The AUX button selects the external source connected to the AUX INPUT on the back panel. · The BGM button selects the external source connected to the BGM INPUT on the back panel. · The DVD button selects the external source connected to the DVD INPUT. · The AUTO button enables the automatic input detection on the AM-170 to select the source. 5. 3D SOUND ­ This button toggles the 3D Sound enhanced audio between off and on. MUTE ­ This button toggles Mute between off and on. · The CDG button selects the external source connected to the CDG INPUT on the back panel. 7. MPX ­ This button selects the various Audio mix settings, toggling among Stereo, Left and Right. Care & Maintenance Use only a slightly dampened cloth to clean the AM170, and dry off with a clean towel. Keep the unit in an area free of excessive moisture, and always allow sufficient room around the unit for airflow. [. . . ] When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or with the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. Following any servicing or repair of this product, ask the service technician to perform the appropriate safety checks to ensure the product is in proper operating condition. The product should not be mounted to a wall or ceiling except as recommended by the manufacturer, with a mounting accessory recommended by the manufacturer. [. . . ]