User manual ACESONIC AM-190 DATASHEET

[. . . ] CET APPAREIL NUMERIQUE RESPECTE LES LIMITES DE BRUITS RADIO ELECTRIQUES APPLICABLES AUX APPAREILS NUMERIQUES DE CLASSE B PRESCRITES DANS LA NORMESUR LE MATERIEL BROUILLEUR: APPAREILS NUMERIQUES , NMB-003 EDICTEE PAR LE MINISTRE DES COMMUNICATIONS. CAUTION To reduce the risk of electrical shocks, fire, etc: 1. Do not remove screws, screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. FCC INFORMATION (U. S. A. ) 1. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Turn counter-clockwise to gradually pan to the stereo left channel. Turn clockwise to gradually pan to the stereo right channel. Center the knob for equal output from both stereo left and right channels. (Please note: the microphone inputs will NOT be affected) 13. MICROPHONE low-cut control- Adjust the low frequency level of microphone input. 14. BBE level adjustment knobs- Adjusts the low/high audio frequency of BBE sound effect. Turn clockwise to increase and counter-clockwise to decrease. 6 Rear Panel Function and Operation 5 12 6 9 10 11 7 8 1. VOLTAGE SELECTOR- Voltage selection switch. Push the switch right for 115V, and left for 230V. (Note: Different regions of the world use different voltage strength. Please check to make sure the correct voltage is selected for your area. ). Before switching, please disconnect the power plug. Use up/down/left/right arrow key for operation. EXIT:Exit from the function, sound-effect setting page. . KEY CONTROL: 1. SHARP button (#)- raises music key by one halftone. 2. NATURAL button ( )- resets music to original key. 3. FLAT button (b)- lowers music key by one half-tone. REV : Microphone reverb effect adjustment 2 . ECHO : Microphone echo effect adjustment 3 . CENTER : Center volume adjustment MIC EFFECT ECHO+REV DEL+REV INPUT SELECTOR 1 2 REVERB 3 ECHO 4 PARAM OSD # b REV ECHO MIC MUSIC VOICE SUB MUTE BBE WOOFER CENTER SOUND EFFECT VOLUME SOUND EFFECT 1. VOICE: Mult . 3. SUB: Switch to subwoofer output(need to connect to active subwoofer) 4. BBE:To enable/disable the dynamic expand effect. 10 Sound-Effect Screen Setting: B 11 Default Volume Setting: INPUT SEL Default Volume and Maximum Volume Setting: 1. Make sure the AM-190 is connect to power and turn POWER SWITCH(#7) OFF. 2. Counterclockwise turns the volume of MUSIC VOLUME(#1) and MIC MASTER VOL(#2) to minimum. 3. Continually press INPUT SEL(#4), and then press POWER SWTICH(#7). [. . . ] It is advised that you keep your bill of sale as proof of purchase, should any difficulties arise concerning the registration of the warranty card. WARRANTY REGISTRATION is made and tracked by MODEL AND SERIAL NUMBER ONLY, not by the purchaser's or owner name. Therefore any warranty correspondence or inquiries MUST include the model and serial number of the product in question. Be sure to fill in the model and serial number in the space provided below and keep this portion of the warranty card in a safe place for future reference. [. . . ]