User manual ACR ELECTRONICS RCL-75

[. . . ] CAUTION: Before proceeding to install, test or use your new ACR Electronics' product, please read this Product Support Manual in its entirety. If you have questions regarding the contents of the manual, please contact our Technical Service Department at ACR Electronics, Inc. , Telephone +1 (954) 981- 3333 or email at service@acrelectronics. com. Please be ready to provide the technician with the page number you wish to discuss. If you have a question that is not covered in the manual, please visit our website and access the Frequently Asked Questions (FAQs) section for further information or call our Technical Service Department. [. . . ] Use a sealant around the cut out to protect from moisture intrusion. Make sure there are no obstructions behind the area where the switch is to be located. bulkheads, wires, plumbing, hardware. ) Check in advance to verify the wiring harness can be routed to this location. Figure 4Point PadTM surface mount Figure 5Point PadTM flush mount Mounting the Light Make sure area is clean and dry. Verify that the backside of the mounting surface can be reached to install nuts and washers. NOTE: If the mounting surface is not flat, a special, shapeable plate can be purchased, (P/N 9427), to adapt the light base to the surface. This plate can also be used to raise the light 1 inch (2. 54 cm) if desired (see Figure 6). Y1-03-0158G 8 Figure 6-Shapeable plate (purchased separately) Remove the deck mounting plate from the light base (4 Allen bolts). Locate the mounting plate on the spot that you want your light. Rotate the plate so that the arrows are pointing forward and the length of the arrow is aligned parallel to the keel. Mark the 4 mounting holes, starting with the hole marked "Front" on the mounting plate. Mounting holes are in 90° increments. Drill 4 mounting holes (1/4") and a centered cable clearance hole (3/4"). Put the mounting gasket on the deck mount (or shaped plate, if used). Use caulk or bedding compound to seal bolt and wire holes before deck mount is attached to deck. The plates are keyed to each other and to the light: Be sure the arrows are pointing in the correct direction. The light will rotate 180° either way from the arrows. Use marine grade 316 stainless steel bolts, nuts, and lock washers to fasten the plate(s) to the mounting surface. Install and connect the control cable and (+) Red and (-) Black power leads. Leave at least 8 inches (20. 32 cm) of wire coiled in the base of light to allow for servicing (see Figure 7). Figure 7 Y1-03-0158G 9 Seat the light assembly on the deck mount. Make sure the key is mated and the gasket edge is not pinched. Reinstall the four (4 ) stainless steel Allen bolts with the flat washer next to the plastic and the lock washer under the bolt head. (Allen wrench for these bolts is furnished). Tighten securely. SECTION 4 - OPERATION The remote control Point PadTM is simple to operate. [. . . ] will repair or, at its option, replace the unit at no cost to you for labor, materials and return transportation from ACR. For further assistance, please contact our Technical Service Department at ACR Electronics, Inc. , 5757 Ravenswood Road, Fort Lauderdale, FL 33312-6645. Email: service@acrelectronics. com, Fax: +1 (954) 983-5087, Telephone: +1 (954) 981-3333. This warranty does not apply if the product has been damaged by accident or misuse, or as a result of service or modification performed by an unauthorized factory. [. . . ]