User manual ACRONIS TRUE IMAGE 9.0 HOME

[. . . ] User's Guide Acronis True Image 9. 0 Home Compute with confidence www. acronis. com Copyright © Acronis, Inc. , 2000-2006. "Acronis", "Acronis Compute with Confidence", "Acronis Snap Restore", "Acronis Recovery Manager, "Acronis Secure Zone" and the Acronis logo are trademarks of Acronis, Inc. Linux is a registered trademark of Linus Torvalds. Windows and MS-DOS are registered trademarks of Microsoft Corporation. [. . . ] These steps look like those in file archive restore. However, watch your selection: if you are to restore files instead of disk/partition, uncheck the unnecessary folders. Otherwise you will restore a lot of excessive files. Then you will be taken directly to Restoration Summary screen (6. 3. 12 Restoration summary and executing restoration). Restore disks or partitions Having selected a usual way of disks/partitions recovery, you will have to make all settings described below. Using Snap Restore When restoring a system disk/partition image from Acronis Secure Zone, you will have the third choice ­ to use Acronis Snap Restore. Having selected this option, you will proceed directly to the summary window (6. 3. 12 Restoration summary and executing restoration). In a few seconds after pressing Proceed the computer will reboot to the restored system. Log in and start work ­ no more reboots or other actions are required. For more about Acronis Snap Restore, see 3. 5 Acronis Snap Restore. When performing Snap Restore, the current Acronis True Image Home version always restores the entire system disk. Therefore, if your system disk consists of several partitions and you are planning to use Acronis Snap Restore, all partitions must be included into the image. Any partitions which are missing from the image will be lost. Snap Restore of Windows 98/Me systems is not available. However, you can choose an ordinary way of restoration for that image. This will allow you to make changes to the restored partition that would not be possible when using Acronis Snap Restore. Finally, if you are not going to recover the system, but only want to repair damaged files, select Restore specified files or folders. Click Next. Copyright © Acronis, Inc. , 2000-2006 35 6. 3. 4 Selecting a disk/partition to restore 1. The selected archive file can contain images of several partitions or even disks. Select which disk/partition to restore. Disks and partitions images contain a copy of track 0 along with MBR (Master Boot Record). It appears in this window in a separate line. You can choose whether to restore MBR and track 0 by checking the respective box. Restore MBR if it is critical to your system boot. Click Next. 6. 3. 5 Selecting a target disk/partition 1. Select a target disk or partition where you want to restore the selected image. [. . . ] Translation Mode parameter can have the following values: LBA Large Normal Match Partition Table Manual New versions of AwardBIOS menu have the Boot item. The screen of the Boot menu, which is responsible for adjusting the boot sequence, looks like this: AwardBIOS Setup Utility Main Advanced Power [None] Boot Exit Boot Sequence: 1. ATAPI CD-ROM 78 Copyright © Acronis, Inc. , 2000-2006 2. Other Boot Drive Plug & Play O/S Boot Virus Detection Quick Power On Self Test Boot up Floppy Seek Full Screen Logo [Legacy Floppy] [IBM-DTLA-307020] [Disabled] [No] [Enabled] [Enabled] [Enabled] [Enabled] <Enter> to select the device To select the boot sequence, use up or down Arrow. [. . . ]