User manual ACTIONTEC AU802C

[. . . ] Introduction Page 2 3 4 7 11 21 22 24 26 ll. Installing the Actiontec 54 Mbps Wireless Access Point V. Configuring the Actiontec 54 Mbps Wireless Access Point VI Troubleshooting VII Frequently Asked Questions VIII Regulatory Notices and Statements IX Warranty Statements Proprietary Notice and Disclaimer Unless otherwise noted, this document and the information herein disclosed are proprietary to Actiontec Electronics, Inc the manufacturer. Any person or entity to whom this document is furnished or who otherwise has possession thereof, by acceptance agrees that it will not be copied or reproduced in whole or in part, nor used in any manner except to meet the purposes for which it was delivered. [. . . ] WEP key 1 - 4 : Enter sequence of leters and numbers (0-9, A-F) to be used as a WEP key. You can set up to four different WEP keys. V For example, a 64 Bit key would be "012FC493E1". Default WEP key to use: Select the Default WEP key to be used by clicking on the arrow. Data transmissions will always be encrypted using the default key. The other keys can only be use to decrypt received data. Authentication: There are three methods to authenticate a client to the access point, Open, Shared Key or Both. - Open- allows anyone to authenticate to the access point. - Shared Key- allows only stations that know the keys to authenticate. - Both- allows a station to use either mode. IP A ddr Here you can configure the IP address used by the Web and TFTP servers running on the Access Point, you can specifiy whether you are using a Static IP or are using a DCHP address provided by a server in your network. These options will not go into effect until the Access Point is rebooted. IP Address Mode: Click on the option better suited for your needs. Static: Check this box to use the IP settings specified on this page. DHCP: Check this box to use the IP settings specified by a DHCP server on your network. Default IP Address: Enter the IP address for the access point. Default Subnet Mask: Enter the subnet mask address, this specifies the number portion of an IP address. The default value for the access point is: 255. 255. 255. 0. Default Gateway: Enter the IP address for the gateway that connects you to the Internet. Access Point Name: This is the name that the access point will use to identify itself to external configuration and Access Point Locator. If you are not using any programs like those mentioned, you can leave it blank. Once you adjust the settings, click on save and reboot the Access Point. A dmin Here you can change the password, reboot the access point, or rest all settings to their factory default values. [. . . ] For any third-party products listed in the Actiontec Electronics software product documentation or specifications as being compatible, Actiontec Electronics will make reasonable efforts to provide compatibility, except where the non-compatibility is caused by a "bug" or defect in the third party's product or from use of the software product not in accordance with Actiontec Electronics published specifications or User Guide. THIS ACTIONTEC ELECTRONICS PRODUCT MAY INCLUDE OR BE BUNDLED WITH THIRD-PARTY SOFTWARE, THE USE OF WHICH IS GOVERNED BY A SEPARATE END-USER LICENSE AGREEMENT. 24 Warranty Statements Right Footer 25 l ll lll lV lV V V Vl Vl Vll Vll Vlll Vlll lX lX X X Xl Xl 24 l ll THIS ACTIONTEC ELECTRONICS WARRANTY DOES NOT APPLY TO SUCH THIRD-PARTY SOFTWARE. FOR THE APPLICABLE WARRANTY, PLEASE REFER TO THE END-USER LICENSE AGREEMENT GOVERNING THE USE OF SUCH SOFTWARE. [. . . ]