User manual ACUMEN PULSE MATE

[. . . ] To check for accuracy, repeat the above procedure. Step 5) Press the / buttons to either increase or decrease the stride (each increment /decrement is 0. 1 feet or 0. 05m) until the desired number is located. Step 6) Press the PROGRAM button once again to stop the flashing screen and switch back to the DISTANCE mode display. Your stride is now locked in the unit. PulseMate Step 4) Press the PROGRAM button once again to stop the flashing screen and switch back to the CALORIES mode display. Your weight is now locked into the program and allows the unit to calculate the calories burned during your exercise. V. [. . . ] Step 3) Press the / buttons to either increase or decrease the weight setting until the desired number is located. Start Recording Press the Start / Stop button once to enter the STOPWATCH mode and the Running-Man figure in the lower left hand corner of the display will also begin to run. This indicates that the unit is now ready to record your distance. Stop Recording To stop recording your distance travelled, press the Start / Stop button again. Note: You may flip up the unit to view the screen and operate the buttons. Acumen Inc. Auto Stop / Scan Flip up the unit to enter the AUTO STOP/SCAN mode. The unit will automatically stop all measuring and begin to scan all of the data that have just been recorded, one by one from STOPWATCH, DISTANCE, STEPS, CALORIES, to AVERAGE SPEED, and back to whichever mode the unit was in before the unit was flipped. Bring the unit back to its original position by flipping it downward. Press the Start/Stop button to begin measuring again. Using the FUNC Button You may press the FUNC button to toggle between the following modes. STOPWATCH DISTANCE STEPS HEART RATE TIME AVERAGE SPEED CALORIES Using & Setting the Clock Press the Time button once to enter the TIME mode, Press and hold the PROGRAM button for one second, the hour will start flashing. Press the / buttons to increase or decrease the hour. Press PROGRAM again and the minute will start flashing, follow the same procedures to adjust the minute. Press the PROGRAM button once more and the time is saved. Note: If no key is pressed within 60 seconds, the unit will exit the Set Mode automatically. VII. CHANGING THE BATTERY Use a coin to open the battery cover. Remove the cover and replace the battery. When finish, turn the cover clockwise until it locks in place. You will need to reset your stride and the clock as these have been erased. Battery Type: Lithium CR 2032 Battery Life: Approximately 1. 5 years VIII. CARING FOR YOUR PULSEMATE · Do not drop the unit. · Do not expose the unit to moisture or high humidity. · Do not expose the unit to high temperatures Check Your Heart Rate shipment or failure which results from accident, misuse, abuse, tampering, alteration or disassembling of the product or improper maintenance. This warranty is effective only if the product is purchased and operated in the USA and does not extend to any units which have been used in violation of written instructions furnished by Acumen Inc. or to units which have been altered or modified without authorization of Acumen Inc. , or to damage to products or parts thereof which have had the serial number removed, altered, defected or rendered illegible. Acumen Inc. , 101 A Executive Drive Suite 200 Sterling, VA 20166. TO RETURN FOR SERVICE Be sure to enclose: a. The date of purchase (or receipt as a gift) c. [. . . ] Securely package and return the product: PREPAID to: Using the Reset Button · The Reset button on the PulseMate is operational ONLY when the unit is stopped, which is indicated by the Running Man being static. · Press the Reset button to set the unit back to zero. It will reset the data recorded in all modes except your recorded stride settings. · Do not press the Reset button if you want to save and accumulated the results over a period of time. [. . . ]