User manual ADI COMMUNICATIONS AT-600

[. . . ] 40 Leaving the "Settings J menu". 51 General problems with the dishwasher . 66 Cleaning the drain pump and non-return valve . 73 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Electrical Safety Before installation, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. [. . . ] The d indicator lights. Sensor Wash Program finished 12:00 Main menu } ^ Select Main menu. ^ Select the desired program. The program starts. 39 Settings J The "Settings J" menu allows you to adjust standard settings Opening the Settings J menu ^ Turn the dishwasher on by pressing the g button. If the memory function is selected, the last selected program is displayed. Switch to the main menu by pressing +C (Clear). } Plate Warming } Settings F Main menu r ^ Select Settings J. The display changes into the menu "Settings J". } Language F } Time of day Settings r ^ Select the desired setting. The selected options in the submenus are marked with a L check. 40 Settings J Language J The display contents can be shown in different languages. The displayed language can be changed by the submenu "Language J". ^ Select the desired language and confirm with OK. The flag behind the word "Language J" serves as a guide when an unfamiliar language is selected. In this case select the respective menu with a flag until the submenu Language J shows. Time of day This selection allows the clock to be shown as 24 or 12 hours. Setting the clock format ^ Select Format. ^ Select the detergent used and confirm with OK. 42 Settings J Water hardness The dishwasher is equipped with a sensor softener, which automatically detects the hardness of your tap water. After plumbing the dishwasher and finishing a program, e. g. "Rinse & Hold", the water hardness is displayed in the menu "Water hardness". ^ Touch OK to change back to "Settings J". Rinse aid For best results, the rinse aid dosage can be adjusted. The dosage can be set in steps from 0 and 6 ml. The dosage is set by default to 3 ml of rinse aid per program. ^ Use a higher setting if spots appear on dry glassware. ^ Use a lower setting if streaking appears on dishes or glasses. ^ Select the desired rinse aid dosage with the +/- controls and confirm with OK. External water softener If the dishwasher is connected to an external water softener unit which is regenerated with salt, the water hadness must still be set in the dishwasher to the water hardness from your water softener unit. If you don't know the value, set the dishwasher water hardness to 8°d (8 gr/gal [US]). ^ Set the dishwasher to the water hardness of the external water softener and confirm with OK. [. . . ] This can be directly connected to a water supply with 3/4" MHT (male hose thread ends). ­ Water pressure: Must be between 4. 5 - 145 psi (0. 3 - 10 bar). If the water pressure is lower, the display shows Water intake see "Frequently asked questions". , Do not drink water from the dishwasher!­ The dishwasher can heat its own water to the temperature required by the wash program. [. . . ]