User manual ADVANCE ACOUSTIC MAP-308 QUICK START

[. . . ] hEED WARNINGS All warnings on the appliance and in the operating instructions should be adhered to. FOLLOW INSTRUCTIONS All operating and use instructions should be followed. WATER AND MOISTURE The appliance should not be used near water for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. VENTILATION The appliance should be situated so that its location or position does not interfere with its proper ventilation. [. . . ] Your product is designed to be placed on a firm and level surface. Don't place the unit sideways, a big power exerts on the single side of the plate. With this power, the plate will be broken easily. The window of the meters is antistatic treated, also, it's very important to clean it with an antistatic approved liquid. To switch on the Power amps direct function, please push "Normal/Amp" button of the remote control during 3 seconds. To cancel this mode, please push on the "Normal/Amp" button of the remote during 3 seconds. STANDBY/ON POWER BUTTON Press this button to turn ON your appliance, power is supplied to your unit and it becomes operational, the STANDBY indicator blue lights after few seconds. (The main power switch is located on the back panel and must be ON in order to use STANDBY function). When set to STANDBY the main power is cut-off and the unit is no longer fully operational except for the micro controller. CD INPUT Press this button to select the CD as your listen source. the audio signal of CD is an analog RCA type connector. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. TUNER INPUT Press this button to select the tuner as your listen source. the audio signal of CD is an analog RCA type connector. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. VOLUME BUTTON Your amplifier used a rotary type knob to control the 2 channel output sound level (left and right). Turn this volume knob clockwise to increase the ouput sound level and turn this volume knob counterclockwise to decrease the output sound level. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. [. . . ] MM/MC SELECTOR You can connect your turntable and adjust the cartridge type (MM or MC cartridge). OFF mode will switch off the meter light and ON mode will switch ON the light of the meters. GROUND SCREW TERMINAL FOR TURNTABLE Connect the ground wire from your turntable here. This connection must be important in minimizing AC hum. [. . . ]