User manual ADVANCE MPP-506

[. . . ] WATER AND MOISTURE The appliance should not be used near water for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. VENTILATION The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed. Sofa, rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. [. . . ] The audio signal of phono is an analog RCA type connector plus an additional ground. On the back panel, you have the possibility to adjust the cartridge type used: MM for moving magnet cartridges and MC for moving coil cartridges. Gh PC RCA, PC JACK AND lp INPUTS Press this button to select the PC RCA (red bottom led), press again to select PC JACK (blue bottom led) and another time to select ip (blue top led). Please note that two inputs connectors for PC JACK and ip are on the front panel, their input levels has been optimised (stereo minijack 3, 5mm). VOLUME BUTTON Your amplifier used a rotary type knob to control the 2 channel output sound level (left and right). Turn this volume knob clockwise to increase the ouput sound level and turn this volume knob counterclockwise to decrease the output sound level. ISOLATING SPIKES Your amplifier used spike-feet, you need to use them with non-skid cupels included. UPGRADE YOUR MPP-506 PREAMPLIFIER Your preamplifier is available in two versions, the MPP-506 (without DAC) and the MPP-506da (with DAC inside). The MPP-506 could be upgrade in MPP-506DA by addind a DAC PCB (ref. The led DAC INSIDE lights up when your preamplifier is a MPP-506DA or a MPP-506 with DAC board inside. To obtain additionnal informations about this upgrade card, please contact your appointed dealer. wARNING ATTENTION No good Good Your product is designed to be placed on a firm and level surface. Don’t place the unit sideways, a big power exerts on the single side of the plate. With this power, the plate will be broken easily. INPUTS You can connect your stereo sources on those inputs. These inputs are suitable for any line level source equipment such as tuners, CD players, DVD, MP3 players, etc. note: These inputs are for analogue audio signals only. They should not be connected to the digital output of a CD player or any other digital device. PHONO INPUT, MM/MC SWITCH AND GROUND TERMINAL You can connect your turntable and adjust the cartridge type (MM or MC cartridge). Turntables normally includes a single wire earth lead. Use the phono ground connector to connect this lead. Unscrew the terminal to expose the hole which will accept the lead. [. . . ] And use the high quality DAC converter of your preamplifier MPP-506DA in order to obtain a better sound result. USB INPUT (ONLY MPP-506DA) Note: Do not turn on the unit until all connections have been made. You can listen music files that are on your computer. Connect a USB ‘B–A’ cable from the MPP-506DA USB input to one of the USB ports on the PC or Mac. [. . . ]