User manual ADVANTOR LCD PLUS KEYPAD

[. . . ] LCD plus Keypad Installation Instructions (P/N: LCD PLUS AVR or LCD PLUS GEN) P/N 09830030 Rev. C See the Advantage 3000 Series Systems Installation and Service Manual or the Advantage plus Service Manual for panel theory and service procedures. See the SONICS Database Management Manual or the Advantage® Access for Windows User's Guide for options programming procedures. Advantage® is a trademark of Advantor Corporation Copyright © 1996-97 by Advantor Corporation. [. . . ] Loop Status Screen tested during a Walk Test (see Figure 7 for an example). While viewing the Loop Status screen pressing Prior displays the previous alarm, pressing Next displays the next alarm. Pressing Quit returns you to the Setup Mode screen (Figure 4). External Beeper Output NOTE: UL requires that there be NO CONNECTION to this output, which goes low while the keypad is beeping. LCD plus KEYPAD SETUP MODE NOTE: Only LCD plus keypad #1 operates while the system is in the Test Mode. Place a system with no options into the Test Mode by powering it up with the TEST/OPER switch (S1) in the TEST position. NOTE: 3350+ and 3250 systems enter Test Mode by powering up with the Tamper loop violated. After power up press "9+8+7+6+ENTER" on the keypad to stay in Test Mode. The keypad displays a SETUP MODE "Waiting for Master Controller" message. HHMM ENTER sets time After approximately 15 select function seconds the LCD plus Test Cal Download keypad displays the Setup Figure 4. LCD Setup Mode Screen Mode screen shown in Figure 4, indicating the system is in the Test Mode. NOTE: Cal displays on only 3350+, 3450 and 3475 systems. The 3250 system and access modules have no audio detection capabilities. Walk Test WALK TEST From the Test Mode in progress screen, pressing the Walk button places the system in push ENTER when done the Walk Test Mode and Figure 8. Walk Test Screen displays the WALK TEST screen shown in Figure 8. Using Walk Test you can perform a functional system test by entering Walk Test then walking around the facility violating alarm loops. Each loop violation and restoral sounds the local bell for 1 second. After violating the loops return to the keypad and press ENTER to exit the Walk Test. The System Test screen in Figure 5 reappears. You can press the keypad "*" key (system status) to see the Walk Test results. Pressing "*" displays the TEST RESULT screen shown in Figure 7. Outputs Test SETTING SYSTEM TIME Any time the LCD plus keypad displays the "HHMM ENTER sets time" prompt you may set or change the system clock. With the phone line disconnected, pressing the On button routes audio from all system audio sensors to the TIP and RING test points on the panel. Pressing the Off button removes the audio from the TIP and RING test points. Pressing the Done button returns you to the initial Setup Mode screen (Figure 4). The Auto Calibration screen "calibrated" listing shows the audio detectors that have been calibrated. This listing updates as detectors are calibrated. [. . . ] Press Done after entering Enter panel account# the phone number. Push ENTER when done Pressing the Enter Acct# Figure 25. Account# Screen button displays the screen shown in Figure 25 and allows you to enter the optioned account number (see the options sheet). Pressing the Quit button returns you to the Call Mode screen (Figure 22). Restore Tamper Dial Mode Switch to operate Use the Dial Mode to force the control panel to dial the central station. [. . . ]