User manual AEG-ELECTROLUX 66200K-MN

[. . . ] Useful tips and hints Environmental information 2 Contents Operating Instructions. Switching the STOP+GO function on and off. 4 4 6 6 6 7 8 8 9 9 9 10 10 11 12 13 16 17 17 17 18 Cleaning and care . 31 3 Operating Instructions 1 Safety instructions 3 5 Please comply with these instructions. [. . . ] The child safety device is set. Releasing the child safety device Step 1. Touch sounds Touch Control panel Switch on the appliance until the signal Display/Signal l Acoustic signal Appliance switches off. The child safety device is released. Overriding the child safety device The child safety device can be released in this way for a single cooking session; it remains activated afterwards. Touch Control panel Switch on the appliance and Display/Signal l at the same time / acoustic signal Until the appliance is next switched off, it can used as normal. 3 12 After overriding the child safety device, a heat setting or a function must be set within approx. 10 seconds, otherwise the appliance automatically switches itself off. Using the timer Function Automatic cut-out Condition a heat setting is set Outcome after the time has elapsed acoustic signal 00 flashes Cooking zone switches off acoustic signal 00 flashes Countdown timer cooking zones not in use 3 3 If a heat setting is set on this cooking zone in addition to a countdown timer, the cooking zone is switched off after the time set has elapsed. If a cooking zone is switched off, the timer function set is also switched off. Selecting a cooking zone Step 1. Control panel Touch TIMER once Display Pilot light of the first cooking zone flashes Pilot light of the second cooking zone flashes Pilot light of the third cooking zone flashes Pilot light of the fourth cooking zone flashes 2. Touch TIMER once 3. Touch TIMER once 4. Touch TIMER once 3 3 If the pilot light is flashing more slowly, the heat setting can be set or modified. If other timer functions are set, after a few seconds the shortest remaining time of all the timer functions is displayed and the corresponding pilot light flashes. Control panel Indicator Select TIMER cooking Pilot light for the cooking zone sezone lected flashes Touch or 00 to 99 minutes After a few seconds the pilot light flashes more slowly. The time counts down. Switching off the timer function Step 1. when appliance is switched or partly covered by oboff jects. The residual heat indicator The cooking zone was only If the cooking zone is supis not displaying anything on for a short time and is posed to be hot, call your therefore not hot local Service Force Centre. The automatic warm up function is not switching itself on There is still residual heat on the cooking zone h The highest heat setting is set Let the cooking zone cool down The highest heat setting has the same power as the automatic warm up function 1. Set the cooking zone using the sensor field The heat setting was set using the sensor field Acoustic signal sounds and The On/Off sensor field has Do not place any objects appliance switches itself on been covered up, e. g. by a on the control panel and then off again; after 5 cloth seconds another acoustic signal sounds _ is lit Overheating protection for Switch off the cooking the cooking zone has been zone. Switch the cooking triggered zone on again 20 Problem Possible cause Electronics fault Remedy Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, e is displayed again, call the customer service department e and number are displayed e and minus are displayed Light rays that are too Briefly shade the control strong on the control pan- panel, for example with el, for example bright sun- the hand Acoustic signal light sounds, appliance switches itself off Switch appliance on (again) 1 3 If you are unable to remedy the problem by following the above suggestions, please contact your local Service Force Centre. Repairs to the appliance are only to be carried out by qualified service engineers. Considerable danger to the user may result from improper repairs. If the appliance has been wrongly operated, the visit from the service technician or dealer may not take place free of charge, even during the warranty period. 21 Disposal 2 Packaging material The packaging materials are environmentally friendly and can be recycled. The plastic components are identified by markings, e. g. Please dispose of the packaging materials in the appropriate container at your local waste disposal facilities. [. . . ] The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. All service work under this guarantee must be undertaken by a Service Force Centre. Any appliance or defective part replaced shall become the Company's property. This guarantee is in addition to your statutory and other legal rights. [. . . ]