User manual AEG-ELECTROLUX AG 934

[. . . ] Along with a wide range of accessories designed and built to the high quality standards you would expect, from specialist cookware to cutlery baskets, from bottle holders to delicate laundry bags. 4 7 8 8 10 11 13 15 16 17 Safety information Control panel First use Daily use Helpful hints and tips Care and cleaning What to do if. The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. [. . . ] It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor. â· Adequate air circulation should be around the appliance, lacking this leads to overheating. Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. â· The appliance must not be located close to radiators or cookers. â· Make sure that the mains plug is accessible after the installation of the appliance. Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. â· This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. To permit storage of food packages of various sizes, the door shelves can be placed at different heights. The sliding box can be placed at different heights. Lift the shelf with the sliding box upwards and out of the holders in the door 2. remove the retaining bracket out of the guide under the shelf 3. Reverse the above operation to insert the sliding box at a different height. Do not open the door frequently or leave it open longer than absolutely necessary. â· If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator. [. . . ] Clean the condenser (black grill) and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operation will improve the performance of the appliance and save electricity consumption. Take care of not to damage the cooling system. Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. [. . . ]