User manual AEG-ELECTROLUX AG 935

[. . . ] it contains safety precautions , hints , information and ideas. If the freezer is used in compliance with the instructions written, it will operate properly and provide you with greatest satisfaction. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. [. . . ] This function can be de-activated at any time by pressing button (D) until the corresponding symbol ( ) flashes on the display again and then by pressing button (E) to confirm the de-activation. Before first use, the freezer should be cleaned inside, see chapter "Care and cleaning". The symbol ( ) will flash on the display and the alarm will beep, since the temperature inside the freezer is not yet sufficiently low for food storage. Only place food inside the freezer once the symbol ( ) has gone. The temperature of the freezer is set to reach -18°C, which is the optimal storage temperature as set in the Eco Mode ( ) Use this function as a safety warning when placing bottles in the freezer, as they may burst when forgotten in the appliance. Press button (D) several times until the corresponding symbol ( ) flashes on the display. Press button (E) within a few seconds to confirm the Drinks Chill activation. The symbol ( ) stops flashing and you will hear a beep. Press button (B) several times or continuously to set the desired number of minutes (from 1 to 90 minutes). It is possible to deactivate this function at any time by pressing button (D) until the corresponding symbol ( ) flashes on the display again and then by pressing button (E) to confirm the de-activation. Press button (A) for more than one second until the countdown "3-2-1" disappears and you hear a sequence of beeps. use hot water and a mild , non-aromatic detergent. Clean the loose accessories and the vented floor, before replacing them again. Never use strong detergents, scouring powder or aromatic detergents to clean your freezer. If the freezer temperature is not sufficiently low, the alarm will beep and the symbol ( ) and the temperature indication will flash on the display. When normal conditions are restored, only the freezer temperature continues to flash. The highest temperature the freezer reached then appears on the display for some seconds. The alarm can be due to: Insertion of a large amount of fresh food. The best time to clean your freezer is after defrosting. Disconnect the appliance from the power supply and remove all loose accessories. use hot water and a mild , non-aromatic detergent. Clean the loose accessories, before replacing them again. [. . . ] Never fill the freezer further than the loading line shown on the illustration. If freezing is too slow, the quality of the food being frozen deteriorates. The amount of fresh food (expressed in kg) that can be frozen in 24 hours is indicated in the chapter "Technical data" under "Freezing capacity". Try the solutions suggested here first to avoid the cost of an unnecessary service call. [. . . ]