User manual AEG-ELECTROLUX CC2050

[. . . ] Repairs carried out by untrained people may result in personal injury or serious malfunction of the appliance. Service of the appliance should be carried out by an authorised service company, and only original spare parts should be used. It is dangerous to alter the appliance specifications, or to change the appliance in any other way. Make sure that the appliance is not placed on top of the mains cable. [. . . ] This appliance includes components that are heated during operation. Consequently, adequate ventilation must always be provided. If ventilation is insufficient defects may occur, resulting in the warming up of the beverage. The inside of the appliance contains pipes through which coolant flows. If these pipes are punctured the appliance may be damaged beyond repair and beverage may warm up. Do not knock inside of the appliance with sharp implements. If the appliance is fitted with a lock to prevent tampering by children, the key must always be kept safely out of the reach of children, and far away from the appliance. Before disposing of an old appliance, make sure that the lock (if present) no longer works. This is to prevent accidents and avoid the danger of children getting locked inside. 3 IN THE INTERESTS OF THE ENVIRONMENT: When disposing of your old appliance: Check with your local Council or Environmental Health Officer to see if there are facilities in your area for collecting the gas from the appliance for recycling. The thermostat has been adjusted to the optimal position by the manufacturer. Please do not adjust the thermostat unless the temperature is lower than 0 °C. PACKAGING AND POSITIONING Never fill the cooler to more than 5 mm below the top edge. LOCK (Not a standard accessory for all models. ) The appliance can only be locked when the upper lid is pushed to the left and the lower lid is pushed to the right. Remember to keep the key out of the reach of children. BASKETS (Not a standard accessory for all models. ) The baskets are designed for the storage of beverage. The handles can be placed in two positions, as shown in the drawings. The baskets can either be placed inside the freezer or hung on the edge of the casing. IMPORTANT 1. Before adjusting the temperature please disconnect the appliance from the electricity supply and remove the plastic grid from the right side of the appliance. Reconnect the appliance to the electricity. It is possible that the compressor does not start immediately after a short-time disconnection from the electricity supply. WARNING Before fitting the plastic grid to the appliance you must not reconnect the appliance to the electricity. 6 MAINTENANCE DEFROSTING The formation of waterdrop or frost on the inside of appliances cannot be avoided. They are formed when moisture contained in the air comes into contact with the cold surfaces of the appliance. [. . . ] WARNING Before fitting the plastic grid to the appliance you must not reconnect the appliance to the electricity. 6 MAINTENANCE DEFROSTING The formation of waterdrop or frost on the inside of appliances cannot be avoided. They are formed when moisture contained in the air comes into contact with the cold surfaces of the appliance. Consequently, the lid should only be opened when necessary, and it should never be left open. Before removing the drip water from the appliance please switch off the current. [. . . ]