User manual AEG-ELECTROLUX DASL55100K

[. . . ] Operating Instructions 1 2 3 f c Extractor Hood 56326 03. 10 DASL55 DASL60 DASL82 DASL90 2 electrolux Dear customer Please read through these operating instructions carefully. You should pay particular attention to the , , Safety Instructions" section. Please keep these operating instructions in a safe place for your reference, and pass them on to any subsequent owner of the appliance. nstructions that are important for your safety or for the operability of the appliance are highlighted by means of the warning triangle, and/or the keywords , , Caution!" or , , Beware!". [. . . ] When the filters have been cleaned, press the function button for 3 seconds until indicator light f goes out (the timer is reset, or enabled if switched off). Activated carbon filter monitor function In recirculating mode and when an activated carbon filter is fitted, it is advisable to enable the monitor function for the activated carbon filter. To enable this function, press and hold button 2 for 10 seconds, until indicator light C comes on. After 120 hours of operation, indicator light C is continuously illuminated when the hood is extended. The activated carbon filter must be regenerated after 120 hours. After the activated carbon filter has been reinserted, press the function button for 3 seconds until indicator light C goes out (the timer is reset). Displaying the Monitoring Functions Pressing the function key makes the LEDs for counters f and C light up, when they are active. Light Light Function button Function button f f c c Grease filter Grease filter Function button Function button f f c c Activated charcoal filter Activated charcoal filter electrolux 11 Cleaning and Maintenance Beware!Do not use any abrasive cleaners, brushes, sponges or scouring powder. External cleaning The external components are to be cleaned with a microfibre cloth. When cleaning the exterior, ensure that the cloth is worked in line with the texture of the stainless steel surface finish (the fine horizontal lines). Cleaning the metal filters The fan is running!Caution: Non-adherence to these cleaning instructions may result in a risk of fire!Push the metal filters up at the rear and pull them out to the front. component 3 Cleaning the metal filters 2. Wash the metal filters every 2 to 4 weeks in the dishwasher, or place them in washing-up liquid and water, rinse them with hot water and allow them to dry completely. Discoloration of the filters is normal; this has no effect on their function. 12 electrolux Reinserting the metal filters 3. Lift up the metal filters at the rear and slot them in place at the front. 3 Cleaning the filter space Clean the filter space with a dry piece of kitchen roll each time the metal filters are cleaned or replaced. Caution: Do not damage or remove the appliance nameplate. Regenerating the activated carbon filter Handling of the activated carbon filter according to operating instructions. Insofar as the appliance is equipped for recirculating operation. Pull down the activated carbon filter at the front and remove it. 5 electrolux 13 Regeneration Moisture and grease particles reduce the absorbent capacity of the activated carbon, so it must be regenerated after 2 months at the latest. [. . . ] One option is to use the protective grid accessory. 5/6= 635 max. 140 4/6= 508 5/6= 635 6/6= 762 5/6= 635 1629 1502 138 325 0-50 2050 319 200 17 ( Griff ) 49 18 electrolux Electrical connections / power lead Caution!The electrical connections must be carried out by an approved installer. The plug must be accessible after installation. [. . . ]