User manual AEG-ELECTROLUX DB5115RP

[. . . ] The iron must not be left unattended while it is connected to the supply mains. Always stand the steam iron on its heel. When placing the iron on its stand, ensure that the surface on which the stand is placed is stable. The iron must be used and rested on a stable surface. [. . . ] Considerable danger may result from improper repairs. If repairs become necessary, please contact the Customer Care Department or your authorised dealer. Lights up (Figure 1/J); it goes out when the temperature set has been reached. However, if the temperature selector (Figure 1/N) is turned back, please note that it takes a while for the soleplate to cool down. Only when the power indicator light comes on again has the soleplate reached the cooler temperature. The water reservoir should only be filled when the plug has been removed from the socket. To do this, you can use the measuring beaker supplied (Figure 1/P). This appliance complies with the following EU Directives: ­ 73/23/EEC of 19. On good quality garments they indicate the correct ironing temperatures. Start with materials that require low temperature ironing (e. Follow on by ironing materials that require progressively higher temperatures. The super steam jet function is of valuable assistance when ironing, for example, creases, embroidery etc. You can trigger the additional steam jet both when steam ironing and when dry ironing. 0 Set the temperature selector (Figure 1/N) to the "max. " position and wait until the correct temperature has been reached, i. , until the power indicator (Figure 1/J) goes out. When using tap water for steaming, limescale is deposited in the steam chamber; heavy deposits reduce the quantity of steam produced. for descaling use lukewarm water and vinegar essence ­ mixing ratio 1:1. Pour the mixture into the appliance when cold and disconnected from the mains (Figure 3). Proprietary brands of descaler are too aggressive and must not be used!Wait until the power indicator (Figure 1/J) goes out. Afterwards repeat the procedure using clear water and then heat the steam iron briefly to allow the steam chambers to dry. [. . . ] Drops of water are coming out of the steam exit holes?­ Do not set the steam selector to position "1" or higher until the temperature for steam ironing has been reached. Rub the soleplate while still warm with a mixture of water and vinegar or with a nonabrasive cleaning agent. ­ When dry ironing fluff can enter the steam chambers and carbonise. [. . . ]