User manual AEG-ELECTROLUX DI9610M-S

[. . . ] Technical data Environment concerns The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Subject to change without notice 4 Safety information SAFETY INFORMATION WARNING!These instructions are only valid in the countries whose symbols appear on this booklet's cover. For your safety and correct operation of the appliance, read this manual carefully before installation and use. [. . . ] ­ Speak to your local authorised facilities for disposal of your appliance. INSTALLATION WARNING!The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. Installation 7 Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I. S. 813 Current Editions and the ETCI Rules for Electrical Installations. Provision for ventilation Detailed recommendations are contained in the following British Standards Codes Of Practice: B. S. The hob should not be installed in a bed sitting room with a volume of less than 20 m³. If it is installed in a room of volume less than 5 m³ an air vent of effective area of 100 cm² is required. If it is installed in a room of volume between 5 m³ and 10 m³ an air vent of effective area of 50 cm² is required, while if the volume exceeds 11 m³ no air vent is required. However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m³ and 11 m³. If there are other fuel burning appliances in the same room, B. S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements. For appliances installed in the Republic of Ireland please refer to the NSAI- Domestic Gas Installation I. S. You can find this plate in the package supplied with the appliance. If the supply gas pressure is changeable or different from the necessary pressure, you must fit an applicable pressure adjuster on the gas supply pipe. Adjustment of minimum level To adjust the minimum level of the burners: Installation 1. With a thin screwdriver, adjust the by-pass screw position. 1 9 1 The by-pass screw ­ If you change from natural gas 20 mbar to liquid gas, fully tighten the adjustment screw in. ­ If you change from liquid gas to natural gas 20 mbar, undo the by-pass screw approximately 1/4 of a turn. Make sure the flame does not go out when you quickly turn the knob from the maximum position to the minimum position. Electrical connection · Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. · Always use a correctly installed shockproof socket. · Make sure that there is an access to the mains plug after installation. · Do not pull the mains cable to disconnect the appliance. · The appliance must not be connected with an extension cable, an adapter or a multiple connection (risk of fire). Check that the ground connection is in conformity with the standard and regulations force. · The power cable must be placed in such a way that it does not touch any hot part. [. . . ] After cleaning, dry the appliance with a soft cloth. ­ Remove immediately: melting plastic, plastic foil, and food containing sugar. ­ Stop the appliance and let it cool down before you clean: limescale rings, water rings, fat stains, shiny metallic discolorations. Use a special cleaner applicable for surface of hob. [. . . ]