User manual AEG-ELECTROLUX DL8560-M

[. . . ] Never use the hood for purposes other than for which it has ben designed. Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. [. . . ] Create an opening in the bottom of the wall mounted unit, as shown (fig. 1), leaving a distance of at least 20mm from the front. Fit the two hood support brackets (fig. The brackets must be fitted differently according to the size of the hood to be mounted. Remove the profile after unfastening the 4 screws that fix it to the Hood (fig. Insert the Hood until it connects with the snap-on side Supports. Lock it in position by tightening screws Vf from underneath the Hood. It is now possible to fasten the hood to the wallmounted unit using the screws 12a (3. When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the pipe in position using sufficient pipe clamps (not supplied). Cut a hole ø 125 mm in any shelf that may be posi-tioned over the hood. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the directional grille 8 on the recirculation air outlet using the 2 screws 12e (2, 9 x 12, 7) provided. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button. When pressed for about 1 seconds the motor is switched off. The function becomes active when the button is pushed for about 2 seconds. After 10 minutes of functioning it turns off automatically. This function can be interrupted by means of pressing any of the buttons. indicates that the Metal grease filters saturation alarm has been triggered , and the filters need to be washed. The alarm is triggered after 100 working hours. [. . . ] When refitting the filters, make sure that the handle is visible on the outside. The filter is not washable and cannot be regenerated. It must be replaced when led S1 flashes or at least every 4 months. The alarm signal will only light up when the extractor motor is switched on. [. . . ]