User manual AEG-ELECTROLUX EDB7510U

[. . . ] · Never pull the plug from the socket by means of the mains cable!· Prior to cleaning or in the event of a malfunction, unplug the appliance first!· The iron is not to be used if it has been dropped, if there are visible signs of damage or if it is leaking. · Do not use the appliance if the mains cable is damaged. [. . . ] Do not exceed the maximum water level indicator. 0 Push the filling aperture cover firmly to close. indicates that the iron is cooling to the selected temperature. To ensure that the iron has reached the selected temperature and is not too hot, wait until the temperature control light comes on again and then goes out before ironing. Dry ironing 0 Connect the steam iron to the mains and set the desired temperature as described above. 0 Select "dry" on the steam selector (Fig. This will cut off the steam flow if there is water in the tank. Steam ironing 0 Connect the steam iron to the mains and set the desired temperature as described above. When steam ironing, ensure that the temperature selector is set to any temperature within the steam band, and that the tank is at least 1/4 full of water. 1/G) to the desired steam setting. 3 The special soleplate design allows you to use tap water with your iron without affecting the steam performance. However, in very hard water areas we recommend the use of distilled or demineralised water. Do not fill the steam iron with fabric conditioner, starches or other solutions as these will damage the steam mechanism. Do not use contaminated water. 1 3 Using your steam iron 0 Plug the power cable into a 220-240 V power outlet. The power ON light (Fig 1/H, positioned on top of the handle) will illuminate to indicate that the steam iron is switched on and is heating up. 1/K) to the desired setting by aligning the setting on the selector with the temperature control light (Fig. The temperature control light will illuminate to indicate that the iron is heating to the selected temperature. When the temperature control light goes out the iron is at the selected temperature and is ready to iron. Using the spray mist The spray mist can be used when steam or dry ironing to predampen hard to iron fabrics. Ensure that the tank is at least ¼ full of water. 1/E) during ironing to release a fine mist from the spray nozzle (Fig. 1/D). 3 Using the steam jet function The steam jet function can be used when dry or steam ironing, when the temperature control is set to any temperature within the steam band or above the two dot (··) setting. 3 When the temperature selector is changed from a high setting to a lower temperature setting during ironing, the temperature control light will go out immediately. This 3 Ensure that the tank is at least ¼ full of water. 5 822 949 465_EDB7510U. book Seite 6 Montag, 26. Januar 2009 9:45 21 g 0 Select the desired temperature and wait until the temperature control light goes out. [. . . ] d. The Company does not accept liability for defects arising from neglect, misuse or accident. Proof of the date of purchase will be required before service under guarantee is provided. For further assistance call Electrolux PLC Floorcare Helpline on 08445 614 614. Calls to this number will be charged at 5 pence per minute at all times from a BT Landline. [. . . ]