User manual AEG-ELECTROLUX EDB8590

[. . . ] Överlämna dem till den nye ägaren till apparaten vid ägarbyte. Använd den medföljande bägaren och häll långsamt vatten i påfyllningsöppningen till det nått upp till den maximala vattennivån (Fig. This appliance corresponds to accepted technological standards with regards to safety. Nevertheless, as a manufacturer we consider it our obligation to make you aware of the following safety information. [. . . ] When changing from a high temperature to a lower temperature, the red temperature control light (Fig. 1/E6) will illuminate and the LCD will flash indicating that the steam iron is cooling down. 0 To reduce the cooling period, turn the steam selector (Fig. Once the steam iron has reached the selected temperature, the green temperature control light (Fig. Before filling the steam iron with water ensure that the plug is removed from the power outlet. The steam iron can be filled with water while it is hot. Place the steam iron on its heel and open the filling aperture cover (Fig. Using the beaker provided, slowly pour water into the filling aperture until the maximum water level (Fig. Do not exceed the maximum water level indicator. Push the filling aperture cover firmly to close. It is safe to use tap water in your steam iron. the anti-calc cartridge removes minerals from the water , preventing scale build-up. However, in extremely hard water areas we recommend the use of distilled or demineralised water. Do not fill the steam iron with fabric conditioner, starches or other solutions as these will damage the steam mechanism. 0 Plug the power cable into a 220-240 V power outlet. The steam iron's twin element construction allows you to iron with maximum steam, even on one dot temperature setting · The spray mist can be used when steam or dry ironing to predampen hard to iron fabrics. 1/E2) during ironing to release a fine mist from the spray nozzle (Fig. The steam jet function can be used when dry or steam ironing. The steam iron's twin element construction allows you to iron with maximum steam, even on one dot temperature setting · 1/E5) several times with the iron on the soleplate to prime the pump. If the water tank has run dry, it may be necessary to re-prime the pump after filling the steam iron with water. [. . . ] Start with a low temperature and gradually increase the heat to find the best setting for ironing the garment. When reducing the temperature to iron sensitive fabrics, allow approximately 2 minutes for the steam iron to cool to the new setting. Pure woollen fabrics (100 % wool) can be steam ironed with the temperature dial set to Wool. Never iron areas of a garment where perspiration marks are visible, as the heat of the steam iron will fix the stains, making them permanent. [. . . ]