User manual AEG-ELECTROLUX EDC68555W

[. . . ] Important safety information Environment Product description Control panel Before first use Programme chart Daily use 2 4 5 6 6 6 7 Cleaning and maintenance 10 What to do if . In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Selecting additional functions You can choose from the additional functions Delicaat (Delicate), Droogtegraad (Dryness), Zoemer (Buzzer ) and Startuitstel (Delay). By depressing button Zoemer (Buzzer) the acoustic signal is switched off in the following cases: · When the programme selector dial is turned to another position during the programme or when you depress an option button during the cycle · at the end of the programme. The corresponding light comes on Startuitstel (Delay) This button allows you to delay the starting of the programme by 3, 6 or 9 hours. Press the button until the light relevant to the desired delay lights up. This option must be selected after having selected the programme and before 3 6 9 pressing START/PAUZE (START/PAUSE) to start the programme. the machine begins the countdown , which is shown by the pilot lights. For example, if you have chosen a 9-hour delay (pilot light 9h lit), after 3 hours, 9h goes out and 6h lights up; after 3 more hours, 6h goes out and 3h lights up. When the 9 hours are over (pilot light 3h off), the drying cycle begins. During the delayed start period, it is not possible to change the programme or the selected delay. If you wish to do so, you must first cancel everything by rotating the programme selector dial to position "O". Select the new programme, the options and the delayed start, then press START/ PAUZE (START/PAUSE) . If you wish to change only the options, this can be done on condition that the new option(s) is(are) compatible with the programme. set the machine to PAUSE by depressing the relevant button , select the new option(s) and depress START/PAUZE (START/PAUSE) button again. If you wish to add some laundry while the machine is performing the countdown, after having done so and having closed the door, press START/PAUZE (START/PAUSE) again, in order to allow the machine to complete the remaining countdown time. After a period of time, a patina due to detergent residue on laundry forms on the When this occurs, clean the filters with warm water using a brush. remove the filter from the door pulling it out. It can be positioned with the tooth facing to the left or to the right). After cleaning do not forget to put it back. The condensed water is not suitable for drinking or for preparing foodstuffs. Remove fluff from lint filter, preferably using a damp hand for this purpose. Clean the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. In order to continue warning lamp the programme, the water reservoir must first be emptied. [. . . ] ⷠThe feet must never be removed. Do not restrict the floor clearance through deeppile carpets, strips of wood or similar. This might cause heat built-up which would interfere with the operation of the appliance. The appliance must therefore not be installed on floors which are not resistant to high temperatures. [. . . ]