User manual AEG-ELECTROLUX EDH97980W

[. . . ] Important Pour des raisons de sécurité et dans le but de garantir un usage correct de l'appareil, nous vous invitons à lire attentivement cette notice d'utilisation, ainsi que les recommandations et les avertissements qu'elle contient avant de procéder à l'installation et à la première utilisation de l'appareil. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface. Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is. Do not restrict the floor clearance through deeppile carpets, strips of wood or similar. This might cause heat built-up which would interfere with the operation of the appliance. The appliance must therefore not be installed on floors which are not resistant to high temperatures. When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. Should the appliance be moved, it must be transported vertically. Pull off adhesive strips from inside machine on top of drum. Electrical connection Details on mains voltage, type of current and the fuses required should be taken from the type plate. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Center. The power supply cable must be accessible after installing the machine. Door reversal To make it easier to load or unload the laundry, the door can be reversed. The engineer will carry out the door reversal at your cost. special accessories · Stack kit Available from your Service Force Centre or your specialist dealer These intermediate installation kits can be used to arrange the dryer and an washing machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. the washing machine is at the bottom and the dryer is at the top. Read carefully the instructions supplied with the kit. Drain kit Available from your Service Force Centre or your specialist dealer Installation kit for direct draining of condensate into a basin, siphon, gully, etc. The condensate tank then no longer has to be drained, it must however remain in its intended position in the machine. Read carefully the instructions supplied with the kit. Pedestal with the drawer Available from your Service Force Centre or your specialist dealer To situate the dryer in optimal high and have some additional space to store (e. [. . . ] Turn it to DRUM LIGHT (if available) or to any programme. Automatic process; this is not a machine fault. empty water reservoir3) , press START PAUSE button. Select time programme or higher drying level (e. [. . . ]