User manual AEG-ELECTROLUX EDV705

[. . . ] We promise that it'll make your life a little easier. Good luck! 136901740-00-11102007 4 electrolux Contents Operating Instructions Important safety information Product description Control panel Before first use Sorting and preparing laundry Programme overview Daily use Care and cleaning What to do if . . . Machine settings Technical data Consumption values Hints for test institutes Installation Environment 5 5 8 9 10 11 12 17 27 34 38 40 41 41 42 47 Service 49 important safety information electrolux 5 Operating Instructions Important safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. [. . . ] The amount of time remaining until the programme is set to start is continuously displayed (e. g. 30' etc). Setting child lock The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. The child lock function locks all buttons and the programme knob. The child lock can be activated or deactivated by holding down the Option and OK buttons simultaneously for 5 seconds. 24 electrolux daily use ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed icon appears in the display to indicate that the child safety device is actiThe vated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. Starting the programme Press the Start/Pause button. The programme progress is shown in LCD by appropriate set of icons. From left to the right, from IRON DRY to ANTI-CREASE icon depends on the drying cycle chosen. in case of CUPBOARD programme the following status icons are visible: . Current cycle progress is marked by flashing dash under status icon. When appropriate part of drying cycle is accomplished dash becomes steady and appears flashing under next status icon. Changing programme To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF Aus and then reset the programme. daily use electrolux 25 The programme can no longer be changed directly once the programme has started. After cleaning do not forget to put it back. 4. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. Clean the entire filter area The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. care and cleaning electrolux 29 8. Remove fluff from the entire filter area. It is best to use a vacuum cleaner for this purpose. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. Press against the large mesh filter until it locks into the interlock. If the fine strainer is not fitted, the large mesh filter will not snap into place and the loading door cannot be closed. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. Emptying the condensate tank Empty condensate tank after every drying cycle. 30 electrolux care and cleaning If the condensate tank is full, an active programme will break off automatically and the EMPTY CONTAINER icon on the display will light up. In order to continue the programme, the condensate tank must first be emptied. The condensate is not suitable for drinking or for preparing foodstuffs. 1. 2 1 Take out drawer containing condensed water container completely 1 and pull up the condensed water container's drainage pipe as far as it will go 2. 2. Pour condensed water out into a basin or similar receptacle. Slide outlet connections in and refit condensate tank. [. . . ] Disconnect cable connector from door lock F. Press snap-in button G in and down, press cover down slightly and remove from front of the machine. Disconnect cable connector from cover G. 46 electrolux installation 12. Change door lock F over to the opposite side, insert the cable connector and screw down the door interlock. [. . . ]