User manual AEG-ELECTROLUX EFA1030X

[. . . ] Strong heat development of open flames could damage the exhaust hood. The exhaust hood`s power supply must be interrupted by pulling the plug before conducting any cleaning or maintenance work. Flambee dishes must not be prepared under the exhaust hood. Never leave the pan unsupervised when frying food. [. . . ] The unit can be uncovered again only once the kitchen has been completely set up and the final cleaning has taken place. Make sure that the unit is disconnected from the power supply. 7 Remove protective box from UV-C lamp (13) Insert the stainless steel filter (586x324 mm) (14) into the hood body (1) Please ensure that the filter is correctly inserted!All filters are equipped with a micro switch which interrupts the hood`s electrical circuit power when it is incorrectly positioned! close the drip collector (11) · The unit is now operational!UV-C Lamp with protective UV-C Lamp without protective carton Heat detec- Hood body with stainless steel filter Insert filter correctly: Page 7 5. Operation 4-button control pad: Hand transmitter: Switch on to level 1: button Switch up to next level: button With the button, you switch the hood to level 1, pressing 2, 3, and then off again. Several times switches the hood to level With the button, you switch the hood to level 3, pressing the button several times in a row switches the hood to levels 2, 1 and 0 After run time button: After pressing this button, the hood works with the set level in after run. There are four after run times which you can select by pressing the appropriate button. Press once = 10 minutes (the light bar/s flash/flashes once) , press twice = 20 minute (the light bar/s flash/flashes twice), press three times = 30 minute (the light bar/s flash/flashes three times) and press four times = 40 minutes (the light bar/s flash/flashes four times). The fan speed can be increased or decreased during the after run time. Light button: By pressing once briefly, the right and left halogen lamp is switched on or off. If the button is pressed for a longer period of time, both halogen lamps at the front and the back are switched on or off. Programming Instructions: Hand Transmitter 4-button control pad: 9 Hold down simultaneously until the green LED on the control panel lights up. Then let go of both buttons at the same time. Hand Transmitter: Press the light button on the hand transmitter until the light goes on or off. The new hand transmitter is programmed to the existing exhaust hood. Switching the halogen reflector lamps (12) Take out defective halogen reflector lamps (12) and press the new lamps into the socket!Do not loosen the halogen lamps with metal objects (e. Screwdriver or knife) because they could scratch the hood body. Removing the Metal Filter with the Ionizer Sheet (7) The unit must be disconnected from the mains before removing the metal filter!When removing the upper metal filter (7) the following must be noted: In order to be able to clean the ionizer sheet, the supply cable from each filter must be detached when removing the filter. [. . . ] 13 Please be at home when the service technician comes because he needs your information. Spare Parts-Accessories: Activated carbon refill pack 1 kg, A. Quality Control The units are subject to the following tests according to VDE 0701 Teil 1 and EN60335-1: · Mechanical visual inspection In addition, a visual inspection is conducted and the accessories are checked for completeness. Your contribution to the proper disposal of this product protects the environment and human health. [. . . ]