User manual AEG-ELECTROLUX EFA9750-1X

[. . . ] The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. [. . . ] Press for more than 1 1/2 seconds and the cooker hood turns OFF, ALL the controls (except the light push button) are disabled (the display is off). Press again for more than 1 1/2 seconds to reset the cooker hood to "stand by". Start and choice of motor speed 1-2-3-1-2. Intensive speed ON/OFF: The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood will revert to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will automatically turn off after 5 minutes. Self-T imer ON/OFF: times all the speed levels (the dot "a" on display is flashing), and then the cooker hood switches off: The self-timer is set as follows: 1st speed level 20 minutes 2nd speed level 15 minutes 3rd speed level 10 minutes The display shows the remaining operation time, at the end of the time an acoustic signal is heard. Display Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds. After reconnecting the power supply wait 15 seconds and then check that the cooker hood is now operating correctly. This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery , the hood is not supplied Y), with a charcoal filter(EFA 9673 ONLY) EFA ONLY) EF so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Set in "OFF the hood. Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). The charcoal filter should only be used if you want to use the hood in recirculation mode. To do this you will need an original charcoal filter (available from your local Service Force Centre). Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated. With normal use the filter should be cleaned every second month (when using the hood 2. The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the charcoal, the filter should be dried in an oven for 10 minutes with a maximum temperature of 100º C. After approximately three years of use, the charcoal filter should be replaced with a new one, as the odour reduction capacity will be reduced. Fitting Position the carbon filter inside the hood to cover the protection grill of the motor. [. . . ] For perforated frame extensions (please refer to measurement E calculated previously): - smaller than 690 mm: this extension requires only one bracket (C1 generally C1); C1 this is already fixed in place. - between 690 mm and 795 mm: fit both C1 brackets. - greater than 800 mm: fit all available reinforcement brackets (2 x C1 + 1 x C2 C2) 2 Use 8 screws to fix each reinforcement bracket in place. Note: One of the two C1 brackets is usually already fitted when the appliance is supplied. [. . . ]