User manual AEG-ELECTROLUX EFC9563

[. . . ] This canopy rangehood is a domestic appliance which has been manufactured and tested to comply with Australian and New Zealand Standard AS/NZS 60335. 2. 31. Canopy dimensions (EFC9563X / EFC9561X) 328mm O163mm* 391mm caution This symbol indicates the possibility of injury or damage to property Meanings of symbols used in this manual are shown below: This symbol indicates never to do this This symbol indicates always do this 900mm 593mm 1175mm (maximum) 100mm caution 500mm Read the following carefully to avoid an electric shock or fire. Young children should be supervised to ensure they do not play with the canopy rangehood. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. [. . . ] NOTE: The height of the underside of the hood body must be a minimum of 600mm above an electric cooktop & 650mm above a gas cook top and a maximum height of 800mm (refer to table below). Distance from hood base to top of hob hob type gas electric minimum* 650mm 600mm maximum 800mm 800mm *ftheinstructionsofthehobspecifyagreaterdistancethanthe I minimum above, then that shall be the minimum height for installation 2. Mark the location for the wall and ceiling bracket fixing points above the hood base using the hood base as the reference point (refer diagram bottom left). nstallwallandceilingmountingbracketswithsuitable I screws (to support a total weight of 30kg) to the wall at the positions marked in diagram bottom left. Remove the protective plastic film from the hood body and hang hood on the mounting brackets then secure at the anti-tilt locations as indicated in diagram bottom left. 344mm (rear to wall) ceiling mounted bracket 46mm (recommended area behind flue cover for power point location) 100mm ceiling 168mm 168mm 303mm Depending on the preferred installation/ducting mode, follow step 5a or 5b below. Using the centre line, secure the ceiling mount bracket to the wall using suitable screws (screws not supplied). Attach the recirculating T-piecetotheceilingmountbracket. Installflexiblepipe between T-piece and fan transition outlet. Use cable ties or suitable duct tape to secure flexible pipe to T-piece. NOTE: When installed in recirculation mode, it is recommended to use a carbon filter to prevent odours being emitted back into the room. The canopy rangehood has been supplied with flexible exhaust pipe and duct transition piece, alternatively a 150mm dia. Continue the centre line to the ceiling. Attach the ceiling mount bracket on the centre line. Fit preferred flue pipe to the fan transition duct. (a) 37mm 155mm 155mm (rear view of hood) wall mounting brackets 523mm anti-tilt fixing points 71mm 324mm 349mm 374mm 399mm hood base top of hob 359mm (rear to wall) ceiling mounted bracket 46mm (recommended area behind flue cover for power point location) 100mm 168mm168mm (rear view of hood) 525mm 138mm 138mm 102mm wall mounting brackets anti-tilt fixing points ceiling 266mm 25mm 155mm 155mm (b) lower back edge of glass top of hob 1 min. lock low medium high light auto off OFF boost caution 328mm O163mm* 391mm 593mm 1175mm (maximum) 100mm 900mm 500mm 331mm O163mm 407mm 698mm 1275mm (maximum) 100mm 850mm 520mm 344mm 37mm 155mm 155mm 46mm 303mm 168mm 168mm 100mm 523mm 71mm 324mm 349mm 374mm 399mm 359mm 266mm 25mm 155mm 155mm 46mm 525mm 100mm 168mm168mm 138mm 138mm 102mm 1 min. lock low medium high light auto off OFF boost Buku petunjuk ini menjelaskan penggunaan canopy rangehood anda yang tepat. [. . . ] Selalu tutupi tungku yang menyala dengan kuali atau panci ketika canopy rangehood sedang digunakan. Selalu matikan tungku gas sebelum memindahkan panci/wajan. [. . . ]