User manual AEG-ELECTROLUX EFC9630X

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. use · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has ben designed. [. . . ] Adjust screws Vr to level the hood body When installing the ducting version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Put connection 15 into the connection support 7. Make sure that the outlet of the extension pieces 14. Connect the air outlet connection 15 to the hood body outlet using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Slightly widen the two sides of the upper Chimney and hook them behind the brackets 7. 1, making sure that they are well seated. Make sure that the outlet of the extensions pieces is aligned with the chimney outlets. lower Chimney · Slightly widen the two sides of the Chimney and hook them between the upper Chimney and the wall, making sure that they are well seated. Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. The hood can be switched on pushing directly onto the requested speed When pressed the motor is stopped, regardless of the speed it is set to. When pressed for 4 seconds it resets the filter alarm signal, with a consequent indication of flashing led S1 or S2. This procedure can be carried out only when the motor is stopped. once the reset procedure is over the led S3 flashes twice. When pressed the motor is set to the first speed. [. . . ] This filter cannot be washed or regenerated, and must be replaced when the EN S2 led starts to flash, or at least once every 4 months. Disconnect the mains power supply to the hood by removing the motor unit power supply cable connector, switching off the power supply at the Mains or turning the Main switch off. Release the touch control after 4 seconds, led S1 and S3 will flash to confirm as follows: · Press the T1 -touch control for at least 4 seconds until the S3 -led flashes twice. [. . . ]