User manual AEG-ELECTROLUX EFCR950X

[. . . ] · If you have any doubts, contact the relevant controlling authority or building inspector's office. · Since the rule for rooms with fuel burning appliances is "outlet hole of the same size as the ventilation hole", a hole of 500-600 cm2, which 33 is to say a larger hole, could reduce the performance of the extractor hood. · If the hood is used in its filtering function, it will operate simply and safely in the above conditions without the need for any of the aforementioned measures. · When the hood is used in its extractor function, the following rules must be followed to obtain optimal operation: -- short and straight outlet hose -- keep bends in outlet hose to a minimum -- never install the hoses with an acute angle, they must always follow a gentle curve only -- keep the hose as large as possible (preferably the same diameter as the outlet hole). [. . . ] The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the unit's front panel: · the light switch switches the hood lamp ON and OFF; · ON/OFF Extractor fan switch - Push-button 1: used to turn the fan off and to set the fan to speed 1. · Push-button 2: used to set the fan to speed 2. · Push-button 3: used to set the fan to speed 3. ON/OFF Extractor fan switch Push-button 1 Light switch Push-button 2 Push-button 3 Fig. 3 Correct ventilation If the cooker hood is to work correctly there must be an under pressure in the kitchen. It is important to keep the kitchen windows closed and have a window in an adjacent room open. If the hood does not function Before you make contact to service Check that the power plug is connected to the wall power outlet and that no fuse is blown. Do not do any operations that can cause hazard or damage to the product. If the problem remains contact your dealer or an approved service company Remember to save the purchase recite and the Warranty card (only used in some countries) denomination. This information you will find on the rating label. Take away the grease filter and you will find the rating label behind. Model: _________________________________ Product number: ________________________ Date of purchase: ________________________ Service and spare parts Service and spare parts you will get via your dealer or service company. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the charcoal, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100º C. After approximately three years of use, the carbon filter should be replaced with a new, as the odour reduction capacity will be reduced. · Mounting Remove the frame i which supports the filter h by turning 90° the two knobs g, Fig. 5. Insert the charcoal mattress inside the frame and put all parts back in their place. · To dismount proceed in reverse order. · Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. · The charcoal filter can be ordered from the ELECTROLUX technical assistance service. h g g i g g h Fig. 6 · Disconnect the cooker hood from the main supply. [. . . ] However, a qualified technician must verify suitability of the materials in accordance with the type of ceiling. The ceiling must be strong enough to take the weight of the hood. During electrical connection ensure the power supply is disconnected at the domestic main switch. · Adjust extension of the hood support structure, as the final height of the hood depends on this, and remember that with installation completed the hood must be at least 50 cm above the cook-top for electric cookers and 65 cm for gas or mixed cookers. [. . . ]