User manual AEG-ELECTROLUX EFCR997U

[. . . ] 45 For both versions: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45 Mounting of carbon filter (for recirculating version) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45 Using the hood . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 46 Intensive speed button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Installation made otherwise could lead to loss of performance and even injuries and /or damage on properties. l The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. Please, keep to the provisions of official directives regarding the question of fumes discharge. l When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. l When installed, the hood must be not less than 65 cm. l The power cord should be drawn so that there is no risk of damage. 41 At use of cooker hood l No food must be cooked flambee underneath the hood. l The use of an unprotected flame is dangerous for the filters and could cause fires. l Never leave the deep-frying or frying pan over a cooker/hob. The oil contained in the pan may spontaneously ignite through overheating. l Observe the filter change or cleaning intervals. 3 43 Mounting of hood l Fit the drilling scheme onto the wall at the right height. 4) The lower edge of the scheme correspond to the lower edge of the cooker hood. l On the drilling scheme is printed a line corresponding to the centre of the appliance; with a pencil draw a line up to the ceiling, this will aid installation procedures. 4) l Drill as indicated on the scheme and fit two dowels, two hooks and two screws 5x45. 4 l Hang the hood, adjust the position using the screws on the hooks of the hood. 5 l From the inside of the hood mark on the wall the point corresponding to the hole which will be used to fix definitively the hood. l Drill two hole (Ø 8mm) and fit two dowels. l From inside of the hood insert the definitive fixing screws. 6 44 l Dismount the chimney support from the chimney unscrewing the two side screws (one per side of the chimney- conserve them). 7) l Dismount the deflector "b" from the chimney support unscrewing the two screws that fix the deflector to the chimney support (conserve the screws). 7) l Fit the chimney support onto the wall close to the ceiling. [. . . ] To turn off the fast speed, before the end of the 5 minutes, press button A or button B. If the hood will be used for recirculation of air, with carbon filter, the warning signal have to be connected as follows: Press the buttons B and G at the same time for about 3 seconds. It should be changed when the Carbon filter saturation LED flashes. Ask the technical assistance service or manufacturing company for a new one. To remove the carbon filter, first remove the grease metal filters and then unscrew the two screws that holds the grease filter and pull the filter down (Fig. [. . . ]