User manual AEG-ELECTROLUX EFG70354X

[. . . ] The risk of self-ignition increases when the oil being used is dirty. Never carry out any flambé cooking under the hood. Always disconnect the unit from the from before power supply before carrying out any work on the hood, including replacing the light bulb (take the cartridge fuse out of the fuse holder or switch off the automatic circuit breaker). It is very important to clean the hood replace and replace the filter at the Failure recommended intervals. [. . . ] You will need an original charcoal filter for the recirculation mode. Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. Correct ventilation: If the cooker Correct hood is to work correctly there must be an under pressure in the kitchen. It is important to keep the kitchen windows closed and have a window in an adjacent room open. The control switches are located on the hood's front panel. Control Functioning of the control panel 1 Key OFF motor 2 Speed selection key (power) 1 3 Speed selection key (power) 2 4 Speed selection key (power) 3 5 Intensive speed selection key (power), this lasts 5 minutes, after which the extractor motor switches off or the hood goes back to the suction speed (power) previously selected. In order to deselect this suction speed, press buttons 1 or 2 or 3 or 4. 6 ON/OFF lights key 7 Settings and reset signals of filter saturation: this key lights up in order to warn you of the fact that the maintenance of the grease filter must be carried out while it is blinking, in order to warn you that the maintenance of the carbon filter must be carried out. After cleaning or replacing the filters, press button 7 for 3 seconds until the grease/charcoal filter key 7 stops flashing. In case you want to install a filter to the active carbons, at the end press key 1 (motor off), then press AND HOLD DOWN key 7, after which ALSO press key 5, a beep and key 7 lights up in order to indicate that the controlling device for the carbon saturation filter is activated. Repeat the procedure in order to disactivate the activated carbon saturation filter signalling device. Verification of the status of the saturation signalling of the carbon activated filters: Briefly press key 7, if this lights up for a few seconds the activated carbon saturation filter signalling device is activated, if key 7 does not light up the activated carbon saturation filter signalling device is not activated. Before performing any maintenance operation, isolate the hood from the off removing electrical supply by switching off at the connector and removing the connector fuse. Through Or if the appliance has been connected through a plug and socket, then the removed from plug must be removed from the socket. The perimeter air suction panels are attached to the cooker hood by a series of pins and coupling springs springs; pull them outwards and detach them from the fastening cable cable. Clean the perimeter air suction panels as often as the grease filters (for more information about gentle cleaning methods, read the paragraph "Cleaning" in the pages that follow). Make sure the panels are attached to the cooker hood properly (snapfastened). The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Hand washing Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. [. . . ] If the hood has been installed below the heights indicated in the installation instructions the motor will cut-out frequently which will damage the hood. If after all these checks, the problem persists, contact your local Service Centre, quoting the model and serial number. Please note that it will be necessary to provide proof of purchase for any inguarantee service calls. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. [. . . ]