User manual AEG-ELECTROLUX EFP5519

[. . . ] The minimum safety distance between the cooker top and the extractor hood is 650 mm. Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. The route of the flue must be as short as possible. [. . . ] 1) at a distance of 125 mm from the front of the wall-mounted unit. According to the chosen air outlet diameter, insert the appropriate flange into the upper exhaust outlet. When the Hood is to be installed not in Line with the wall-mounted units (fig. Screw the fastening profile 20 to the rear part of the hood using the screws 12f (2. When installing the Hood in Line with the wall-mounted units (fig. 7) in such a way that it covers the gap remaining between the hood and the wall, using the 3 screws 12f (2. Screw the resulting profile to the hood body, using the 3 screws 12f (2. Insert the Hood until it connects with the snap-on side Supports. Lock it in position by tightening screws Vf from underneath the Hood. Should it be necessary to make adjustments to the inside of the filter holder element, proceed as follows: Move the whole filter holder element until it is properly aligned with the wallmounted unit. It is now possible to fasten the hood to the wall-mounted unit using the screws 12a (3. DUCTING VERSION AIR EXHAUST SYSTEM When installing the hood in ducting version, a rigid or a flexible pipe with the diameter corresponding to the flange diameter is used in order to connect the hood to the air outlet piping. Fix the pipe with an adequate quantity of clamps (not supplied). Cut a hole ø 125 mm in any shelf that may be positioned over the hood. [. . . ] Replace the light with a new one of the same type and rating. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ]