User manual AEG-ELECTROLUX EFT6529B

[. . . ] 5 - Appliance in class II are provided with a double insulation; therefore do not connect then through earthed plugs but through simple bipolar plugs. 6 - When installed, the hood must be positioned at least 65cm above the hotplate. [. . . ] Using the cardboard template, mark and drill the bottom of the wall unit, (see instructions on the template). Fasten the hood from inside the unit using four screws 4, 2 x 44, 4 (supplied) (fig. For suction hoods, the wall unit must be drilled to allow for the air discharge duct. Filter hoods do not require this type of drilling Operation since the air is recycled into the room through vents situated on the front of the hood. 1 - Connecting suction hoods (air is discharged into the atmosphere) The hood comes with two air outlets, a plastic cover fitted in the rear hole and a flange to be fitted according to the solution chosen: top discharge (fig. In case of installation with rear discharge, fit the plastic cover in the top hole and the flange in the rear hole. 10), check that the lever (hood with one motor) or the handle (hood with two motors) points to the ducting mode position (fig. 11), remove the charcoal filter, if any, by turning the handle anti-clockwise (see par. 1 2 - Connecting filter hoods (air is filtered and recirculated inside the room) Open the grid panel, check that the lever (hood with one motor) or the handle (hood with two motors) points to the filter mode position (fig. Moreover, special attention must be paid to the following warnings during the use and maintenance of the cooker hood: 4. 1- The grease filters and the charcoal filters should be cleaned or replaced as recommended by the manufacturer or more frequently if the hood is used consistently (more than 4 hours per day). 2- When using a gas hob in connection with the cooker hood never leave the burners of the hob uncovered while the hood is in use or when the pans have been removed. Switch off the gas before removing the pan or for just short periods and never leave the hob unattended. 3- Always ensure that the appliance is kept at the correct intensity to prevent the flame from licking round from the bottom of the pan; this will save energy and will avoid a dangerous concentration of heat. [. . . ] When cleaning the hood: - Never use a wet cloth or sponge, or running water. - Never use thinners or products containing alcohol, as they might damage the paintwork. [. . . ]