User manual AEG-ELECTROLUX EGS6343

[. . . ] EGS6343 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . EN HOB USER MANUAL 2 www. electrolux. com CONTENTS 1. 13 WE'RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. [. . . ] · Set the cooking zone to "off" after use. · Do not use the appliance as a work surface or as a storage surface. · If the surface of the appliance is cracked, disconnect immediately the appliance from the power supply. Risk of fire or explosion. ENGLISH 5 1. 4 Care and Cleaning WARNING!· Clean regularly the appliance to prevent the deterioration of the surface material. · Do not use water spray and steam to clean the appliance. · Clean the appliance with a moist soft cloth. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. 1. 5 Disposal WARNING!· Contact your municipal authority for information on how to discard the appliance correctly. · Disconnect the appliance from the mains supply. · Cut off the mains cable and discard it. · Flat the external gas pipes. 2. PRODUCT DESCRIPTION 2. 1 Cooking surface layout 1 2 1 Cooktop 3 4 2 Semi-rapid burner 3 Triple Crown burner 4 Auxiliary burner 5 Control knobs 5 2. 2 Control knobs Symbol Description no gas supply / off position ignition position / maximum gas supply Symbol Description minimum gas supply 3. Refer to "Safety information" chapter. 6 www. electrolux. com 3. 1 Ignition of the burner WARNING!Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame Always light the burner before you put cookware. To light the burner: Turn the control knob counterclockwise to the maximum position ( ) and push it down. Keep the control knob pushed for approximately 5 seconds; this will let thermocouple to warm up. If not, the gas supply will be interrupted. Adjust the flame after it is regular. 1. A B C D If after some tries the burner does not light, check if the crown and its cap are in correct positions. A) B) C) D) Burner cap Burner crown Ignition candle Thermocouple WARNING!Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute. [. . . ] · The appliance must not be connected with an extension cable, an adapter or a multiple connection (risk of fire). Check that the ground connection is in conformity with the standard and regulations force. · The power cable must be placed in such a way that it does not touch any hot part. · Connect the appliance to the mains with a device that lets to disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm, eg. [. . . ]