User manual AEG-ELECTROLUX EGS9353NOX

[. . . ] We promise that it'll make your life a little easier. Good luck! The following symbols are used in this user manual: 117979240 - 092007 Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information 4 electrolux Contents Safety information Product description Control panel First use Set the water softener Use of dishwasher salt Use of rinse aid Daily use Load cutlery and dishes Use of detergent Multi-tab function Select and start a washing programme 5 7 8 10 10 12 13 14 15 18 20 21 Unloading the dishwasher Washing programmes Care and cleaning What to do if. . . Technical data Hints for test institutes Installation Water connection Electrical connection Environment concerns 23 24 25 27 30 30 31 32 34 35 safety information electrolux 5 Safety information · Do not take any dishes out of the dishwasher before the end of the washing cycle. [. . . ] Once the programme is running, the "Multi-Tab function " can NO longer be changed. If you want to exclude the "Multi-tab function " you have to cancel the programme setting and then deactivate the ''Multi-Tab function''. In this case you have to set a If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. · The activation/deactivation of the rinse aid can only be possible with the Multi-tab function active. Activation/deactivation of the rinse aid dispenser 1. Simultaneously press and hold function buttons B and C, until the lights select and start a washing programme electrolux 21 of function buttons A , B, and C start flashing. Press function button B, the lights of function buttons A and C turn off while the light of function button B goes on flashing. To activate the rinse aid dispenser, press button B again, the End indicator light illuminates, indicating that the rinse aid dispenser has been activated. To memorise the operation, switch off the dishwasher by pressing the On/Off button. To deactivate the rinse aid dispenser again, follow the above instructions until the End indicator light turns off. Fill up the salt container and the rinse aid dispenser again. Hot steam may escape when the door is opened. Open the door carefully. Cancel a delay start or a washing programme in progress · Simultaneously press and hold the two Cancel buttons (function buttons B and C) until all the programme lights illuminate and in the digital display 3 horizontal lines appear. · Cancelling a delay start involves also the cancelling of the washing programme set. In this case you have to select the washing programme again. With the delay start function set, the programme in progress indicator unloading the dishwasher electrolux 23 · If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. · The End indicator light will illuminate. · The light of the programme just ended will remain on. Switch off the dishwasher by pressing the On/Off button. Open the dishwasher door, leave it ajar and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Interrupt a washing programme in progress · Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. · Press the On/Off, all lights will turn off. Press the On/Off button again; the programme will start from the point at which it was interrupted. End of the washing programme · The dishwasher will automatically stop and the programme in progress indicator light turns off. Unloading the dishwasher · Hot dishes are sensitive to knocks. [. . . ] To a stand pipe provided with venthole, minimum internal diameter 4 cm. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. Water inlet hose with safety valve After connecting the double-walled water inlet hose, the safety valve is next to the tap. Therefore the water inlet hose is only under pressure while the water is running. If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water. [. . . ]