User manual AEG-ELECTROLUX EHET66CS

[. . . ] user manual Ceramic glass hob EHET66CS, EHET96CS 2 electrolux Electrolux. Thinking of you. Share more of our thinking at www. electrolux. com Contents Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Description of the Appliance . . . . . . . . . . . . . . . . . . . 3 Operating the appliance . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Sharp objects and abrasive cleaning materials will damage the appliance. Sharp cleaning agents will damage the appliance. Remove residues with water and washing up liquid. Cleaning the appliance after each use: 1. Rub the appliance dry using a clean cloth. Removing deposits Remove Type of dirt sugar, food containing sugar plastics, tin foil limescale and water rings fat splashes shiny metallic discoloration at once yes yes ------when the appliance has cooled down ----yes yes yes using a scraper1) a scraper1) cleaner for glass ceramic or stainless steel 1) cleaner for glass ceramic or stainless steel1) cleaner for glass ceramic or stainless steel1) 1) *Scrapers and cleaners for glass ceramic and stainless steel can be purchased in specialized shops Removing deposits 1. Place a scraper on the glass ceramic surface at an angle. Remove residues by sliding the blade over the surface. 3. Wipe the appliance with a damp cloth and a little washing up liquid. Rub the appliance dry using a clean cloth. 12 electrolux Remove stubborn residues with a cleaner for glass ceramic or stainless steel. Scratches or dark stains on the glass ceramic that cannot be removed do not however affect the functioning of the appliance. Warning!Residues from cleaning agents will damage the appliance. Remove residues with water and washing up liquid. What to do if . . . Problem The cooking zones will not switch on or are not functioning. Possible cause More than 10 seconds have passed since the appliance was switched on The child safety device is switched on Several sensor fields were touched at the same time Automatic switch off has been triggered Remedy Switch the appliance on again. Deactivate the child safety device (See the section "Child safety device") Only touch one sensor field Remove any objects (pan, cloths, etc. ) that are lying on the control panel. Switch the appliance on again Switch off the lock (See the section "Locking/unlocking the control panel") Remove objects. The lock is switched on Acoustic signal sounds when appliance is switched off The control panel is wholly or partly covered by objects. The residual heat indicator The cooking zone was only on for a is not displaying anything short time and is therefore not hot The automatic warm up There is still residual heat on the function is not switching it- cooking zone self on The highest heat setting is set If the cooking zone is supposed to be hot, call the Customer Service Department. Let the cooking zone cool down The highest heat setting has the same power as the automatic warm up function 1. Set the cooking zone using the sensor field Do not place any objects on the control panel The heat setting was set using the sensor field Acoustic signal sounds and appliance switches itself on and then off again; after 5 seconds another acoustic signal sounds is lit The On/Off sensor field has been covered up, e. g. by a cloth Overheating protection for the cooking zone has been triggered Automatic switch off has been triggered Switch off the cooking zone. Switch the cooking zone on again Switch off the cooking zone. Switch the cooking zone on again electrolux 13 Problem and number are displayed Possible cause Electronics fault Remedy Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, is displayed again, call the customer service department If you are unable to remedy the problem by following the above suggestions, please contact your dealer or the Customer Care Department. Repairs to the appliance are only to be carried out by qualified service engineers. Considerable danger to the user may result from improper repairs. If the appliance has been wrongly operated, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. Technical data Model PNC Product dimensions (w x d) mm Cut-out dimensions (w x d) mm Voltage (volts) Cycles (Hz) Service Cord elements left front left rear right front right rear total no. [. . . ] You agree that any replaced Appliances or parts become the property of Electrolux. This warranty does not apply to light globes, batteries, filters or similar perishable parts. Parts and Appliances not supplied by Electrolux are not covered by this warranty. Where you are within an Electrolux service area, this warranty covers the cost of transport of the Appliance to and from Authorised Service Centres of Electrolux and travelling costs for representatives of the Authorised Service Centre to and from your home or business. [. . . ]